登录
首页 » Others » FS_FAT32

FS_FAT32

于 2009-04-27 发布 文件大小:765KB
0 143
下载积分: 1 下载次数: 19

代码说明:

  FAT32文件系统 基于LPC2200,前后台环境,可自己修改适配于各种RTOS。 验证环境: 搭载LPC2200的SmartARM2200开发板,使用该板上的SPI总线利用该程序读写SD卡 由于试验的SD卡比较特殊,1簇仅1扇区,所以不排除该程序对于非该情况的出错可能(FAT32 file system based on the LPC2200, the environment around Taiwan, can modify their own adaptation in a variety of RTOS. Verification environment: SmartARM2200 with the LPC2200 development board, using the on-board SPI bus of the use of the program to read and write SD card SD card as a result of testing is rather special, 1 cluster only 1 sector, so the program does not exclude the situation for non- error may)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • SPI_STM32_FPGA
    STM32F1与FPGA通过SPI进行通信,我上传的是32部分的程序,已经通过串口测试成功。此程序可拓展为和单片机,DSP通过SPI进行通信(STM32F1 and FPGA communication through the SPI, I uploaded the 32 part of the procedure has been successfully tested through the serial port. This program can be extended to and single-chip, DSP communication through the SPI)
    2020-11-16 09:29:42下载
    积分:1
  • ZB220GDNZ_PSR
    ZB220GDNZ_PSR测控装置的IEC61850配置的icd文件(ZB220GDNZ_PSR of IEC61850)
    2014-01-03 14:32:59下载
    积分:1
  • 12
    说明:  基于AD9854的DDS外围电路设计和程序(The AD9854 DDS based peripheral circuit design and procedures)
    2013-07-24 19:23:13下载
    积分:1
  • sensor
    仅使用一个热敏电阻和一个10K电阻、104电容,在MSP430上实现的精度可达0.1度的温度测量代码。(Only using a thermistor and a 10K resistor, capacitor 104, temperature measurement code achieved accuracy up to 0.1 degree on the MSP430 .)
    2013-12-17 08:16:48下载
    积分:1
  • 温度检测
    本系统是基于STM32F103RBT6微控制器所设计的温度测量系统,通过温度芯片传感器 DS18B20 测量温度,微控制器驱动液晶模块显示当前测得的温度。该测温系统应用测温传感器DS18B20.通过DS18B20把温度值转换成数字量,把数字量送给微处理器,并在液晶显示器上显示出来(This system is based on the temperature measurement system designed by the STM32F103RBT6 micro controller. The temperature is measured by the temperature chip sensor DS18B20, and the micro controller drives the liquid crystal module to display the current temperature. The temperature measurement sensor DS18B20. converts the temperature value into the digital quantity by DS18B20 and sends the digital to the microprocessor and displays it on the liquid crystal display.)
    2018-06-12 18:25:41下载
    积分:1
  • adxl345
    说明:  此程序是使用ADXL345三轴重力传感器和433超再生无线模块结合,在重力感应下,通过发射模块将方向信号发射给接受模块,从而控制小车的方向。(This program uses adxl345 three-axis gravity sensor and 433 super regeneration wireless module. Under the gravity induction, the direction signal is transmitted to the receiving module through the transmitting module, so as to control the direction of the car.)
    2019-12-31 19:24:55下载
    积分:1
  • USART_WakeUpFromStop
    STM32 使用串口从休眠停止模式唤醒例程(Stop using the serial STM32 wake-up Sleep)
    2020-08-27 10:38:13下载
    积分:1
  • fet140_dac12_01
    msp430f169 dac12操作 430单片机有丰富的外围模块其中dac12是12位数模转换器(msp430f169 dac12 Fuzeng 430, such as brazing ⑵ Lennon ape bleed at the nose cavity and Dragonflies俋峓lose Yao [12 trap笢dac12 Did yiu tub蛌distanceけ)
    2007-08-21 12:55:52下载
    积分:1
  • LCD_Blinky
    LCD blinky for lpc 1768
    2015-03-31 03:13:17下载
    积分:1
  • Mega128_Sleep_Wake
    It was a ATmega128 Sleep mode and awake mode programed by avr studio4
    2013-06-03 18:48:50下载
    积分:1
  • 696516资源总数
  • 106405会员总数
  • 10今日下载