-
monte_carlo
Monte carlo simulation
- 2013-04-10 23:49:21下载
- 积分：1
-
C_C.m
混沌理论中用于计算滞后时间t和维数m的C-C方法，，matlab程序(Chaos theory CC method used to calculate the lag time t and dimension of m ,, matlab program)
- 2015-01-21 14:39:37下载
- 积分：1
-
matlab
根据伪随机序列理论，由混合同余法产生均匀分布的随机数，进而根据中心极限定理来产生高斯噪声。
分析所产生的均匀分布和高斯分布随机信号的均值、方差、自相关等数字特征，估计其概率密度函数并进行分析，估计其功率谱密度并进行分析。说明该高斯噪声是否符合白噪声特性。
对该高斯噪声进行FIR低通滤波，估计输出低通型限带白噪声的功率谱、相关时间等，并结合白噪声通过线性系统相关理论来进行分析。
(According to the theory of pseudo-random sequence, a uniformly distributed random numbers by mixed congruential method to generate Gaussian noise, and then according to the central limit theorem. Produce a uniform distribution of the analysis and the mean of the Gaussian distribution random signals, variance, since the digital characteristics of the correlation, the probability density function is estimated and analyzed, it is estimated that its power spectral density, and analyzed. The Gaussian noise is in line with the characteristics of white noise. FIR low pass filter of the Gaussian noise, the estimated output of low-pass type band-limited white noise power spectrum, time, etc., combined with the white noise to be analyzed by linear system theory.)
- 2012-12-19 09:29:22下载
- 积分：1
-
1
说明： 周克敏 鲁棒控制基础（essential of robust control） 书后部分习题(周克敏the basis of robust control (essential of robust control) part of the book Exercises)
- 2007-11-22 20:28:25下载
- 积分：1
-
matlab_file_on_dq_transformation_of_network_compo
matlab file on BASICS OF ELECTRIC MACHINES AND TRANSFORMATION
- 2010-11-30 18:56:21下载
- 积分：1
-
C11调度光伏、风机和无功补偿装置
C11调度光伏、风机、无 功优化补偿装置协调的调度(C11 dispatching photovoltaic, fan and reactive power optimization compensation device coordinated scheduling)
- 2020-11-19 19:39:38下载
- 积分：1
-
GA-of-genetic-algorithms
遗传算法原理及应用 遗传算法的基础应用，是遗传算法的基本知识(Principle and Application of genetic algorithm based on genetic algorithm applications, basic knowledge of genetic algorithms)
- 2011-05-07 17:03:15下载
- 积分：1
-
POST
用来求PST问题，聚类分析的一些重要的复杂的实际性方法等等。(POST is very good way of solving simple matter)
- 2014-09-05 14:45:35下载
- 积分：1
-
three-modal-synthesis-method
给出了三种动态子结构方法的程序，对比了自由界面模态综合法，固定界面模态综合法，双协调自由界面模态综合法三种方法。(Shows three dynamic substructure method of procedure, compared to the free interface modal synthesis method, fixed-interface modal synthesis method, two-coordinate free interface modal synthesis method of three methods.)
- 2020-12-15 08:49:13下载
- 积分：1
-
RA ra_snr_gui.m 作用
ra_snr_gui.m
作用：统计不同信噪比下，五种信号的峰值旁瓣比RA和低高频均值比RM，绘制结果，参考图3.11和3.12
DFCW_RA_SNR.m
作用：产生正交离散频率编码信号，并计算峰值旁瓣比RA和低高频均值比RM
LFM_RA_SNR.m
作用：产生线性调频信号，并计算峰值旁瓣比RA和低高频均值比RM
OFDMLFM_RA_SNR.m
作用：产生正交频分线性调频信号，并计算峰值旁瓣比RA和低高频均值比RM
PC_RA_SNR.m
作用：产生正交相位编码信号，并计算峰值旁瓣比RA和低高频均值比RM
SIN_RA_SNR.m
作用：产生单载频信号，并计算峰值旁瓣比RA和低高频均值比RM
输入参数：
vSNR：信噪比向量
输出结果：
RA:峰值旁瓣比向量RA，对应信噪比向量
RM:低高频均值比向量RM，对应信噪比向量
calculateRA.m:
作用：计算不同信噪比下峰值旁瓣比RA和低高频均值比RM，参考论文3.4.5节
输入参数:
sig：输入信号，可以是多行MIMO信号，运算中将合并为1行信号
vSNR：信噪比向量
输出结果：
RA:峰值旁瓣比向量RA，对应信噪比向量
RM:低高频均值比向量RM，对应信噪比向量
sig_dfcw.m
作用：产生正交离散频率编码信号
sig_ofdm.m
作用：产生正交频分线性调频信号
sig_pc.m
作用：产生正交相位编码信号
(ra_snr_gui.m action: Statistics different SNR peak sidelobes than five signal RA and low high frequency average ratio RM, rendering the results, referring to Figure 3.11 and 3.12 DFCW_RA_SNR.m effect: generating orthogonal discrete frequency encoded signal, and calculate the peak sidelobe ratio RA and low and high frequency average ratio RM LFM_RA_SNR.m effect: generating chirp signal and calculates the peak sidelobe ratio RA and low high frequency average ratio RM OFDMLFM_RA_SNR.m effect: generating an orthogonal frequency division chirp signal and calculates peak sidelobe ratio RA and low and high frequency average ratio RM PC_RA_SNR.m effect: generating quadrature phase encoded signals and calculate peak sidelobe ratio RA and the average low and high frequency effects than RM SIN_RA_SNR.m: to produce a single carrier frequency signal, and calculate peak sidelobe ratio RA and RM lower than the average high-frequency input parameters: vSNR: SNR vector output: RA: peak sidelobe ratio v)
- 2020-06-27 04:00:01下载
- 积分：1
