登录
首页 » Unix_Linux » exp02_PORTB_LED_to_show_how_to_use_bdm_619308775

exp02_PORTB_LED_to_show_how_to_use_bdm_619308775

于 2010-11-08 发布 文件大小:243KB
0 151
下载积分: 1 下载次数: 5

代码说明:

  汇编实现点灯汇编实现点灯汇编实现点灯汇编实现点灯汇编实现点灯(Lighting assembly to achieveLighting assembly to achieveLighting assembly to achieveLighting assembly to achieve)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Source-Code
    实现光伏微网逆变器的代码,使用microchip公司的16位芯片,开发环境采用mplab8.7以上,可用,无错误(Realization of photovoltaic grid-connected inverter micro-code, use the microchip company 16 chip development environment using mplab8.7 more available, error-free)
    2013-09-21 10:16:04下载
    积分:1
  • timer
    输出12路死区互补同步中间对齐PWM的定时器配置(Timer Configuration of 12-way Complementary Dead Zone Synchronized Intermediate Alignment PWM)
    2020-06-25 13:40:02下载
    积分:1
  • SPI(STC15F204PNRF24L01)
    STC51单片机GPIO口模拟串口,实现包含UART、SPI、IIC等(STC51 microcontroller GPIO port simulation serial port and realize UART, SPI, IIC, etc )
    2015-09-05 14:51:26下载
    积分:1
  • Carrier_0_03.tar
    CARRIER todo esto es un documento elaborado con la mayora facilidad
    2013-12-14 04:43:26下载
    积分:1
  • Emc-of-Inverters-in-Low-P
    Emc of Inverters in Low Power Wireless Technology Environment Within Globally Unlicensed 5 GHZ ISM Short-Range Radio Frequency Band
    2013-11-11 20:03:59下载
    积分:1
  • Si4355_RCdemo_SW
    FSK无线SI4355 芯片开发实例,已实现数据的收发功能和芯片的控制配置功能(Control configuration capabilities FSK wireless SI4355 chip development example, it has achieved data transceiver functions and chips)
    2015-06-02 15:17:33下载
    积分:1
  • STM32-IIC
    自己根据3.5库改进的STM32硬件IIC,使用DMA,解决网上其他例程弊病,内含完整工程,运行通过。(IIC STM32 hardware itself according to the 3.5 library improvements, using DMA, other routines to solve the Internet s ills, including complete engineering, running through.)
    2020-11-18 17:29:38下载
    积分:1
  • 新建 Microsoft Word 文档
    说明:  超声波传感器数据采集,arduino实现。并在道路检测中使用(The data acquisition of ultrasonic sensor is realized by Arduino. And it is used in road detection)
    2020-11-27 17:09:35下载
    积分:1
  • mlme_linux
    Restore the PMK information to securitypriv structure for the following connection.
    2015-11-09 20:01:47下载
    积分:1
  • chuankoutongxin
    1.由上位机发送1给单片机时,蜂鸣器以400ms频率发声,发2时以200ms频率发声,发3时以100ms频率发声,发4时关闲蜂鸣器。 1.以2400bps从计算机发送任一字节数据,当单片机收到该数据后,在此数据前加上一序号然后连同此数据一起发送至计算机,当序号超过255时归零。 2.以16进制发送一个0-65536之间的任一数,当单片机收到后在数码管上动态显示出来,波特率自定。 3. 用AD以1HZ的频率采集模拟信号,然后转换成数字量,再将其以1200bps发送到计算机,在计算机上显示。 4.按下矩阵键盘第一行时以1200bps发送,1,2,3,4,第二行时以2400bps发送5,6,7,8,第三行以4800bps发送,9,10,11,12,第四行以9600pbs 发送,13,14,15,16. (1. From the PC to send a single chip, the buzzer to 400ms frequency of sound, made 2 to 200ms frequency sound, made from 3 to 100ms frequency sound, made 4 free buzzer off. 1. To 2400bps from the computer to send any byte of data, when the microcontroller receives the data in this data with a serial number before then sent along with the data to the computer, the serial numbers when more than 255 zero. 2. To send a 16-hexadecimal any number between 0-65536, when the microcontroller in the digital receipt is displayed on a dynamic, custom baud rate. 3. 1HZ with the frequency of AD in order to capture analog signals, then converted to digital, and then send it to 1200bps to the computer, the computer display. 4. Press to 1200bps matrix keyboard to send the first row, 1,2,3,4, 5,6,7,8 the second row to 2400bps send the third line to 4800bps send, 9,10,11,12 , the fourth line to 9600pbs send, 13,14,15,16. )
    2010-12-10 22:53:34下载
    积分:1
  • 696516资源总数
  • 106562会员总数
  • 4今日下载