登录
首页 » matlab » anisodiff

anisodiff

于 2009-11-24 发布 文件大小:1KB
0 203
下载积分: 1 下载次数: 57

代码说明:

  二维的各项异性扩散方程,根据偏微分方程中的p-m编写的。(failed to translate)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • IllustrationMod
    mode shapes of a shaft supported by fluid film bearing(this codes gives a good method to calculate the mode shapes of a shaft supported by fluid film bearing)
    2009-05-29 13:58:32下载
    积分:1
  • 2
    混沌系统仿真软件,用于混沌系统的仿真;通过分析系统的参数和初始状态来观测混沌系统的运行轨迹。(Chaotic system simulation software for simulation of chaotic systems,Through the analysis of the parameters and the initial state of system to measure the trajectories of chaotic systems. )
    2013-08-26 17:09:43下载
    积分:1
  • SUBTRACTIVE-CLUSTERING-
    IDENTIFICATION OF RULES USING SUBTRACTIVE CLUSTERING
    2014-02-20 10:19:02下载
    积分:1
  • magic_and_Foc2
    带参数的汽车轮胎公式模型,亲测可出图,可修改参数(Formula model of automobile tire with parameters can be plotted and parameters can be modified.)
    2021-03-31 23:39:09下载
    积分:1
  • pll
    仿真了锁相环工作到一定时间后达到锁定状态的过程,程序采用的是一阶RC低通滤波器即二阶一型环(Simulation of the PLL to work until after a certain period of time to achieve lock-state process, the procedure is used first-order RC low-pass filter that is second-order one-ring)
    2007-12-12 11:01:42下载
    积分:1
  • cdf_example
    此函数举例描述了一种实现CDF画图的方法,该方法简单易行(This function for example, describes an implementation of CDF drawing method is simple)
    2021-02-08 15:09:54下载
    积分:1
  • FLAC3D地震荷载加载动力计算常用天津波完整原始数据
    FLAC3D地震荷载加载动力计算常用天津波完整原始数据(Commonly used Tianjin wave complete raw data)
    2020-07-05 09:40:02下载
    积分:1
  • va_decode
    这是关于va检测的程序。 仿真参数为: 帧数:1000 帧长:100 调制方式:bpsk 信道:3径rayleigh慢衰落信道 接收:VA检测 文件有:bpsk.m;dec_bpsk.m;trellis.m;viterbi_my.m;main.m(This is about the va testing procedures. Simulation parameters: number of frames: 1000 Frame Size: 100 Modulation: bpsk Channel: 3 Path slow rayleigh fading channel receiver: VA inspection documents: bpsk.m dec_bpsk.m trellis.m viterbi_my.m main.m)
    2010-09-02 15:08:53下载
    积分:1
  • wave_method_fault_location
    本程序是利用单端电气量依据行波原理实现故障测距的程序,需要较高的采样率以提高精度。(This procedure uses traveling wave principle of the single-terminal electrical information in accordance with the procedure of fault location, it requires a higher sampling rate in order to improve accuracy.)
    2020-08-17 14:58:22下载
    积分:1
  • PDFS
    WEIBULL PDF MATLAB CODE
    2014-07-31 12:53:20下载
    积分:1
  • 696518资源总数
  • 105873会员总数
  • 12今日下载