登录
首页 » matlab » galiosfield

galiosfield

于 2010-11-19 发布 文件大小:2KB
0 70
下载积分: 1 下载次数: 5

代码说明:

  generation Galois filed and adding and multiplying

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • exp02_NLMS
    NLMS算法的仿真程序,初级入门的matlab仿真程序(NLMS algorithm simulation program, the initial entry of matlab simulation program)
    2008-05-29 17:06:13下载
    积分:1
  • cc6mpid
    pid仿真控制器,设计了一个最简单的pid仿真器,并将其模块化(pid emulator)
    2009-05-30 19:59:08下载
    积分:1
  • ask
    自己编程产生一种二进制调制信号,为数字调制信号的识别做准备。(Their programming to produce a binary modulation signal, the recognition of digital modulation signals in preparation.)
    2010-05-11 12:23:08下载
    积分:1
  • LS-SVMxianxing
    基于最小二乘支持向量机对传感器的非线性系统用MATLAB软件进行仿真建模程序(Based on least square support vector machine (SVM) of the nonlinear system of sensor with MATLAB simulation modeling software program)
    2012-04-15 20:08:32下载
    积分:1
  • MATLAB-wavelet-analysis
    MATLAB小波分析的程序,这是一个信号处理程序,用于故障诊断(MATLAB wavelet analysis procedure, which is a signal processing program for fault diagnosis)
    2020-07-16 17:18:49下载
    积分:1
  • shooting
    shooting 打靶法,MATLAB编程,仅供参考。(shooting shooting method, MATLAB programming, for reference only.)
    2021-01-29 00:48:39下载
    积分:1
  • rgb2hsi
    this M-file is a rgb2hsi transformer
    2010-12-05 16:24:48下载
    积分:1
  • ganshetuchengxu
    说明:  模拟干涉图像的程序,matlab编写,很实用,对正在学习的朋友有帮助。(Interference image of the process simulation, matlab written, very practical, and helpful friends are learning.)
    2010-04-08 02:25:46下载
    积分:1
  • eee
    杨氏双缝干涉 两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2, 满足相干条件的光波叠加后,对于观察屏上某一确定点,即r1、r2确定后,叠加后的光强为 式中λ为光波的波长, 、 ,令相位差φ=2π(r2-r1)/λ, 最后可得公式如下: , 最后光强I=4I0cos2(Φ/2)。 观察相干光叠加后光强的分布. (Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)
    2013-01-03 21:04:13下载
    积分:1
  • tiaoyatiaosuzuihou
    直流电机的调压调速仿真源程序,在simulink中 (DC motor speed regulator simulation source code)
    2015-04-19 15:45:30下载
    积分:1
  • 696524资源总数
  • 103783会员总数
  • 41今日下载