-
gsxyf
高斯消元法程序，高斯消元法程序11111111(高斯消元法程序)
- 2010-07-21 17:16:23下载
- 积分：1
-
SAR-pro
MATLAB编写的SAR成像程序，数据采用的是仿真数据(matlab prepared SAR imaging program, using the simulation data.)
- 2013-12-26 13:55:42下载
- 积分：1
-
direct_torque_control
matlab simulation of dtc fed im
- 2014-02-26 01:49:10下载
- 积分：1
-
FOFDM_Rayleigh
可以计算ofdm系统和F-ofdm系统下的误码率与信噪比变化(The error rate and SNR of OFDM system and F-ofdm system can be calculated)
- 2018-05-04 12:15:49下载
- 积分：1
-
zr
说明： 用双线性变换法设计一个Butterworth低通滤波器，要求其通带截止频率100Hz，阻带截止频率200Hz，通带衰减小于2dB，阻带衰减大于15 dB，采样频率为500 Hz。(Using bilinear transformation to design a Butterworth low-pass filter, requiring that their pass-band cutoff frequency 100Hz, stopband cutoff frequency 200Hz, pass-band attenuation is less than 2dB, stop-band attenuation greater than 15 dB, a sampling frequency of 500 Hz.)
- 2010-06-23 20:51:53下载
- 积分：1
-
LinearPP
The liear principle analysis code
- 2010-10-20 16:03:53下载
- 积分：1
-
IMC_control
说明： IMC控制器设计源程序，已通过matlab，控制效果较佳(IMC controller design source code, has passed matlab, better control effect)
- 2021-03-03 09:59:34下载
- 积分：1
-
NeuCom2008Gong
A population-based artifi cial immune system for numerical optimization
A population-based artifi cial immune system for numerical optimization(A population-based artificial immune system for numerical optimization A population-based artificial immune system for numerical optimization)
- 2013-02-12 11:42:33下载
- 积分：1
-
ex4
IEEE 802.11a系统OFDM仿真。假设OFDM系统物理层采用802.11a系统物理层参数，其中，1个长训练符号与6个OFDM数据符号构成1帧，信道为单径瑞丽衰落信道，接收端采用理想信道估计和利用训练符号进行信道估计时的误比特性能(IEEE 802.11a system OFDM simulation
Assuming that the OFDM system physical layer uses the 802.11a physical layer parameters, among them, 1 long training symbols and 6 OFDM data symbol consisted of 1 frames, the channel into a single path Ruili fading channel, the receiver uses the ideal channel estimation and utilizes the training symbols to estimate channel bit error performance of the)
- 2020-12-30 15:19:00下载
- 积分：1
-
8259.asm
直接用手动产生单脉冲作为中断请求信号。 要求每按一次开关产生一次中断,在屏幕上 显示一次“TPCA Interrupt!”,中断10次后 程序退出(Directly by hand to produce a single pulse as an interrupt request signal. Each time you press the switch requires an interrupt is generated, show a TPCA Interrupt! On the screen, interrupted 10 times after the program exits)
- 2014-12-14 10:06:38下载
- 积分：1
