-
Quantify
发送端采用严格的开根号升余弦滤波器,而发送端采用进行过量化处理的开根号升余弦滤波器,仿真量化处理对系统性能的影响(Sender strict roots and raised cosine filter, while the sender had used for the quantification of the roots and raised cosine filter, simulation, quantification of the impact on system performance)
- 2009-09-21 19:33:54下载
- 积分:1
-
MATLAB_Gaussian-Pepper-Noise-Generator
MATLAB给图像添加高斯、椒盐、加性及乘性噪声[噪声生成]源代码Gaussian-Pepper-Noise-Generator(MATLAB——Gaussian-Pepper-Noise-Generator)
- 2009-02-26 14:10:02下载
- 积分:1
-
PLL_simple
PLL simulator on MATLAB
- 2010-11-04 12:04:58下载
- 积分:1
-
Nearest-neighbor-interpolation
使用最近邻插值法对图像进行缩放处理的matlab程序(Using the nearest neighbor interpolation image zoom processing matlab program)
- 2012-04-23 22:37:55下载
- 积分:1
-
stabilityfactor
研究1维FDTD的收敛情况,分情况讨论stability factor小于,大于,等于1的情况(The convergence of one-dimensional FDTD case, the situation points to discuss stability factor is less than, greater than, equal to 1)
- 2011-09-22 11:19:30下载
- 积分:1
-
linear-FM-chirp-signal-generate-
说明: 切普信号生成,可以改变信号的起始频率和最终频率。(Be able to generate a linear-FM “chirp” signal that sweeps in frequency fromω1 = 2pi*f1 to ω1 = 2pi*f2 as time goes from t = 0 to T2. You can change any of these values.)
- 2011-03-31 09:19:23下载
- 积分:1
-
problem1
MATLAB codes for Finite Element Analysis
problem1.m
antonio ferreira 2008
- 2013-10-01 18:58:53下载
- 积分:1
-
primary
大规模MIMO系统导频分配问题的一种分配方案基础性的代码(A fundation method of pilot arrangement on massive MIMO)
- 2021-04-18 13:28:57下载
- 积分:1
-
acvancedPIDcontrol
这是先进PID控制书中的源码,是基于matlab的。(This is the advanced PID control of the source book is based on the matlab.)
- 2009-01-28 14:43:29下载
- 积分:1
-
802-11a
Original code for OFDM chain applicated to wireless standard
- 2010-09-18 18:28:52下载
- 积分:1