-
a4
说明： 本程序由matlab编写，通过求解光纤激光器的速率方程，给出激光功率分布(This program prepared by matlab, the rate of fiber lasers by solving the equation for the distribution of laser power)
- 2009-10-26 13:34:10下载
- 积分：1
-
signal
信号发生器,生成多种效果的声音，并用matlab编写了guide界面，(signal produce)
- 2011-09-12 00:12:33下载
- 积分：1
-
bistablePsyetem
随机共振运用于弱信号检测，同时对于其中的频谱能够很好的分析。(Weak signal detection applied to stochastic resonance, while for the spectrum which can be a good analysis.)
- 2013-10-26 09:44:24下载
- 积分：1
-
SingleNeuralNetPID
基于二次型学习算法的单神经元PID控制器源代码(Single Neural Net PID Controller based on second Type learning Algorithm)
- 2010-07-09 19:22:46下载
- 积分：1
-
GPSR_6.0
GPSR_6.0 工具器，梯度投影法CS恢复，很有用的(GPSR_6.0)
- 2010-08-12 11:02:04下载
- 积分：1
-
Smart_antenna_System
关于智能天线系统的matlab仿真源程序。(smart antenna systems Matlab simulation source.)
- 2006-07-28 12:02:00下载
- 积分：1
-
suijizikongjian
随机子空间的matlab主程序代码，可以实现高精度的信号辨识。按照《基于随机子空间和最小二乘法的介质损耗角测量方法》、常军博士论文《随机子空间方法在桥梁模态参数辨识中的应用研究》编写。(Stochastic subspace matlab main code, you can achieve high-precision recognition. Accordance with the " stochastic subspace-based least-squares method and dielectric loss angle measurement methods" , regular army doctoral thesis " stochastic subspace identification of modal parameters of the bridge in the applied research" to write.)
- 2021-05-08 23:28:40下载
- 积分：1
-
Counter1s
counter number one to nine after 1s
- 2014-10-22 15:54:51下载
- 积分：1
-
form
在NX平台上，利用二次开发工具创建孔、型腔、边倒圆，并进行相对定位(On the platform of NX, using NX second development tools to create a hole, cavity, edge rounding, and relative positioning)
- 2015-03-29 15:34:09下载
- 积分：1
-
funciones-potencia
Analisis de fallas en sistemas de potencia
- 2011-09-16 00:10:36下载
- 积分：1
