登录
首页 » matlab » simulink(s-function)

simulink(s-function)

于 2010-12-02 发布 文件大小:3KB
0 161
下载积分: 1 下载次数: 29

代码说明:

  用SIMULINK的S-FUNCTION代码编写的BPSK仿真,在瑞利信道和白色高斯噪声信道两种条件下。(The S-FUNCTION with the SIMULINK code written BPSK simulation, the Rayleigh channel and white Gaussian noise channel under two conditions. )

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • LBM-flow-around-circular-cylinder-
    基于matlab语言的格子玻尔兹曼方法的圆柱绕流程序,直接在matlab里运行就可以得到相应的结果了(Based on the matlab language Lattice Boltzmann flow around a circular cylinder procedures run directly in matlab can get the corresponding results of the)
    2013-10-31 16:34:49下载
    积分:1
  • danboshuchengxing
    单目标,窄带波束成形,精确定位,常规波束成形小程序(Single target, narrowband beamforming, precise positioning, conventional beamforming applet)
    2011-11-12 20:35:25下载
    积分:1
  • shujunihe
    在数学建模数据拟合中用这个matlab程序很好用(Mathematical modeling of the data used in this matlab program fit well with the)
    2013-12-15 17:38:22下载
    积分:1
  • IEEE5busloadfluntuation
    IEEE 5 Bus Load fluctuation
    2016-05-16 14:02:42下载
    积分:1
  • QAM
    QAM Modulation of a random sequence after passing a rayleigh channel.
    2013-04-26 18:16:32下载
    积分:1
  • Modern_Optical_Engineering(2007)
    国外几何光学、光学设计经典入门教材,浅显易懂,比较全面(Foreign geometrical optics, optical design classic entry materials, easy to understand, more comprehensive)
    2015-04-11 10:37:34下载
    积分:1
  • Link-a-System-Level-OFDM-Simulator
    针对OFDM系统,分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度,采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada)
    2011-08-09 11:00:53下载
    积分:1
  • [emuch.net]parafacmodeling_ver2.0
    用matlab编辑平行因子分析法,程序不大,容易理解(Using matlab to edit parallel factor analysis method, the program is not big and easy to understand.)
    2019-03-31 16:54:00下载
    积分:1
  • power
    编写的数值分析power方法matlab程序(numerical method for power method )
    2009-11-13 10:13:52下载
    积分:1
  • rf
    说明:   This is a collection of MATLAB functions and scripts, and a Simulink model library, useful for designing and analyzing RF communication systems. The block library was originally intended for use in simulating a GPS system. However, the GPS blocks are incomplete and untested due to the abandonment of the GPS project.
    2009-07-01 05:16:32下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载