登录
首页 » matlab » lcx

lcx

于 2008-06-03 发布 文件大小:6KB
0 271
下载积分: 1 下载次数: 29

代码说明:

  关于泄漏同轴电缆性质,参数的仿真,基于matlab。包括表面波、单模、多模辐射,辐射角,辐射方向图等等。上传者原创程序,专业型很强,非常稀少。(Leakage coaxial cable on the nature of the simulation parameters, based on matlab. Including surface wave, single-mode, multi-mode radiation, the radiation angle, radiation pattern and so on. From original procedure, highly professional, very scarce.)

文件列表:

lcx
...\chapter3.2.2.m
...\danmoduomo.m
...\discrete antenna.m
...\jisuan.m
...\lcxeight.m
...\三种工作模式的比较.m
...\介质衰减和频率的关系.m
...\测试 表面波、单模、多模.m
...\耦合损耗、辐射衰减、频率的关系.m
...\表面波、单模、多模.m
...\辐射方向图1.m
...\辐射方向图2.m
...\辐射角.m

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • eye
    本试验是用数字基带处理方法来实现调试期算法的基带硬件实验。 通过用软件matlab进行了GMSK相位路径和眼图的仿真,之后对任何一种五位随机码,每周期八次的任一抽样时刻,和任一相位区域(0、1、2、3)的任一组合,计算出相位 ,并对 以及 进行1024位的量化、编码成10位二进制码表。进一步利用matlab从上述的码表得出GMSK基带波形的眼图,和理论上计算的眼图比较,一致性很好。(眼图主程序) (This test is a method to realize the digital baseband processor debugging phase algorithms with hardware-based experiments. By using the software matlab a GMSK phase path and the eye diagram of the simulation, after any one of five random code, eight times per cycle of any one sampling time, and any one-phase region (0,1,2,3) of any combination of one to calculate the phase, and 1024 as well as quantitative, encoded into a binary code table 10. Further use of matlab code from the above tables GMSK baseband waveform eye diagram and eye diagram theoretically compared to a good consistency. (Eye diagram of main program))
    2008-07-18 16:08:04下载
    积分:1
  • Gardner
    matlab语言编写的gardner的定时同步算法仿真程序(matlab language gardner Timing Synchronization Algorithm Simulation Program)
    2021-01-14 10:58:47下载
    积分:1
  • Carrier_Trace
    包括载波跟踪和伪码相位跟踪,用Matlab实现直接序列扩频信号的跟踪程序。(Including pseudo-code tracking and carrier phase tracking using Matlab implementation of direct sequence spread spectrum signal tracking procedures.)
    2009-03-13 15:14:42下载
    积分:1
  • PIDcontrowithAOC
    说明:  除了蚁群算法,可用于PID参数优化的智能算法还有很多,比如遗传算法、模拟退火算法、粒子群算法、人工鱼群算法,等等。(In addition to ant colony algorithm can be used to optimize the PID parameters there are many intelligent algorithms, such as genetic algorithms, simulated annealing algorithm, particle swarm optimization, artificial fish-swarm algorithm, and so on.)
    2010-03-28 09:41:56下载
    积分:1
  • mmsp
    前后向平滑算法:算法的原理很简单,以五点三次平滑为例。取相邻的5个数据点,可以拟合出一条3次曲线来,然后用3次曲线上相应的位置的数据值作为滤波后结果。简单的说就是 Savitzky-Golay 滤波器 。只不过Savitzky-Golay 滤波器并不特殊考虑边界的几个数据点,而这个算法还特意把边上的几个点的数据拟合结果给推导了出来。(Before and after the smoothing algorithm: the principle of the algorithm is very simple, to 5.3 times smooth as an example. Take the adjacent five data points, you can fit out a curve 3 times, and then use the corresponding position on the third time the data value as the filtered results. Simply said is the Savitzky-Golay filter. However, the Savitzky-Golay filter does not specifically consider several data points of the boundary, and this algorithm also specifically to the edge of a few points of the data fitting results derived.)
    2017-02-28 14:43:31下载
    积分:1
  • lcx
    关于泄漏同轴电缆性质,参数的仿真,基于matlab。包括表面波、单模、多模辐射,辐射角,辐射方向图等等。上传者原创程序,专业型很强,非常稀少。(Leakage coaxial cable on the nature of the simulation parameters, based on matlab. Including surface wave, single-mode, multi-mode radiation, the radiation angle, radiation pattern and so on. From original procedure, highly professional, very scarce.)
    2008-06-03 10:04:31下载
    积分:1
  • LTE_Simulator
    LTE的系统级仿真平台的搭建,包含每个模块,以及每个模块如何使用,都有介绍,里面还包含两个pdf文档(LTE System Level Simulator Documentation,This document contains documentation on how to use the Long Term Evolution (LTE) System Level simulator [1] as well as some insight on its structure and the assumptions that were made while developing it. This document relates more on how to actually use the simulator. The concept and the structure of the simulator is described in more detail in [2])
    2012-03-06 18:35:40下载
    积分:1
  • JavaJICQ)
    说明:  java编写完成的简单通信工具。类似于ICQ(prepared a simple communications tool. Similar to ICQ)
    2006-03-20 13:49:36下载
    积分:1
  • Trackdemo
    说明:  用于对基于GOLD码的串行捕获算法,可以自定义信噪比,待捕获信号参数,代码分成搜索跟踪和捕获两部分,其中搜索的步长等参数也可以自定义,代码中acquiresignal.m部分为最终捕获相位展示的主程序。(For the serial acquisition algorithm based on GOLD code, we can customize the signal-to-noise ratio and the parameters of the signal to be captured. The code is divided into search part and capture part, The parameters such as search step can also be customized. Acquiresignal.m part is the main progress to output the results of the capture of phase.)
    2019-05-28 15:09:06下载
    积分:1
  • demo_turbo
    matlab编写的turbo码示例程序,用于通信系统的信道编解码仿真(matlab prepared turbo code sample procedures for communication system simulation channel codec)
    2008-04-26 21:23:14下载
    积分:1
  • 696518资源总数
  • 106174会员总数
  • 31今日下载