-
STM32F2xx_StdPeriph_Driver
STM32F2XX系列单片机开发板的库函数
(Library Functions STM32F2XX Series MCU development board)
- 2020-06-26 21:00:01下载
- 积分：1
-
实验15：串口通信
说明： 51单片机串口通信模拟实验，串口通信入门。(51 SCM serial communication simulation experiment, serial communication introduction.)
- 2020-05-21 17:43:13下载
- 积分：1
-
单片机基础实验源代码
测试CC2530，完成基础的功能测试，包括I/O口，串口，无线(Test CC2530, complete the basic functional test, including I/O port, serial port, wireless)
- 2018-04-27 10:53:12下载
- 积分：1
-
CH375-SLAVE
USB 1.1 Slaver for CH375:CH375做slaver的程序,单片机用89C2051.与我之前上传的CH375-HOST对应,联系起来使用.
(USB 1.1 Slaver for CH375 : CH375 do slaver procedures, Microcontroller with 89 C2051. Before I uploaded CH375- HOST counterpart and linked use.)
- 2007-03-14 15:59:27下载
- 积分：1
-
595_c51
基于单片机的点阵屏，595 Z字移位，1/4扫描。(Microcontroller-based dot-matrix screen, 595 Z character displacement, 1/4 scan.)
- 2013-11-25 18:00:27下载
- 积分：1
-
P1ExE
P1口扩展实验
P1口既做输入口又做输出口，KEY1做为左转弯开关，KEY2做为右转弯开关。LED5、LED6做为左转弯灯，LED7、LED8做为右转弯灯（如图2-2）。 编程实现汽车转向灯功能，即：KEY1接高电平KEY2接低电平时，右转弯灯灭，左转弯灯以一定频率闪烁（注意：KEY拨向上方为0）；KEY2接高电平KEY1接低电平时，左转弯灯灭，右转弯灯以一定频率闪烁；KEY1、KEY2同时接低电平时，发光二极管全灭；KEY1、KEY2同时接高电平时，发光二极管全亮。(P1 I extended not only to do experiments P1 I also do input output, KEY1 switch as a left turn, KEY2 as switches and turn right. LED5, LED6 as a left turn lights, LED7, LED8 as lights and turn right (Figure 2-2). Programming car turn signal function, namely: KEY1 high key2 access low-level access, the right turn lights out, left turn to a certain frequency of flashing lights (Note: KEY allocated to the top to 0) KEY2 access high Key1 low-level access, the left turn lights out, turn right to a certain frequency of flashing lights KEY1, KEY2 low at the same time, the light-emitting diode body KEY1, KEY2 high at the same time, the light-emitting diode light-wide.)
- 2008-12-22 22:31:26下载
- 积分：1
-
ComFilter串口过滤器V2.0
带接收和发送协议处理的串口调试工具，可只接收并显示自定义关键字的串口数据，非常好用，带这种功能的可用的此类软件不多，值得收藏。(ComFilter,can receive and display your expired information from COM.)
- 2020-06-24 17:40:02下载
- 积分：1
-
Trafficlightcontroller
说明： (一) 设计交通灯控制的软硬件，实现交通灯的控制。
(二) 交通灯的红、绿、黄灯亮灯时间可以通过键盘设定。
(三) 交通灯控制要有直道、弯道及非机动车的通行、停止控制。
(四) 在某一方向通车或停车时，要有动态的指示，消除司机的烦躁情绪。
(五) 红灯停、绿灯行、黄灯停止未过线的机动车和停止方向的预启动。
(六) 黄灯亮的时间不可改变，预定5秒钟。
((A) the traffic light control software and hardware design to realize the control of traffic lights. (B) the traffic lights red, green, yellow light time can be set via the keyboard. (C) of the traffic light control should be straight, curved and non-motor vehicle traffic, and stop control. (D) the direction of traffic or parking in a while, there must be a dynamic instructions, eliminating the driver' s irritable mood. (E) red light stop, green, and yellow lines to stop the vehicle has not been the direction of the pre-start and stop. (F) yellow light time can not be changed, scheduled for 5 seconds.)
- 2020-10-27 11:29:58下载
- 积分：1
-
VCPPFileMonitor
本程序可自动监测被测主机中的所有文件的操作，通信包截获等(The program can operate automatically monitor files, such as intercepted communications package)
- 2015-04-09 13:53:57下载
- 积分：1
-
Old_Arduino_Drivers
用于arduino单片机驱动错误的修复。如电脑无法识别。或被电脑识别为usb设别而非串口。(t is used to repair driving errors of Arduino single chip computer. If the computer can not recognize. Or it can be recognized as a USB device rather than a serial port by a computer.)
- 2020-06-17 18:00:01下载
- 积分：1
