-
3500_mikrosxem
3500 chip power amplifiers, low frequency and their analogues
- 2011-01-18 15:28:47下载
- 积分：1
-
OFDM-frame-synchronization
说明： 基于能量差分的ofdm帧同步算法matlab程序，可以运行(OFDM frame synchronization based on energy difference of the received preamble，can run)
- 2011-03-03 09:36:26下载
- 积分：1
-
MATLAB.7_0
说明： 精通matlab教程。 很好用的。适合初级使用者~~~(useful matlab lesson~~~)
- 2011-03-03 17:36:16下载
- 积分：1
-
simulinkbasic
matlab的基础教学。对初学者有帮助。(matlab basis of teaching. For beginners)
- 2012-09-03 19:22:55下载
- 积分：1
-
ofdmwaterfilling
已知信道状态信息情况下的基于注水法功率分配的OFDM系统 并且和其它系统比较(Known channel state information in case of water injection method based on the OFDM power distribution system and other systems and compare)
- 2008-07-08 15:06:55下载
- 积分：1
-
comparison_21022013
COMPARISON OF DIFFERENT MODULATION SCHEMES
- 2013-11-14 16:30:45下载
- 积分：1
-
matlab-introduction
武汉大学matlab课程课件，仅供学习交流(Wuhan University matlab courseware, only to learn communication)
- 2014-01-14 10:14:24下载
- 积分：1
-
CWPMatlab
CWP:波场中心软件，由SEISMIC UNIX代码改写为matlab版本。(matlab version for seismic unix)
- 2010-06-06 17:17:18下载
- 积分：1
-
xinhao
信号盲分离的程序，对盲信号处理的可以作为参考(Blind separation procedures, blind signal processing can be used as reference)
- 2009-10-07 21:22:31下载
- 积分：1
-
GMSK_QPSK_8PSK
说明： 里面有8PSK，GMSK的matlab源程序，贡献出来了(I was interested in the theory for 8PSK and came across this m-file written in 1999. It
requires 2 function calls (graymapPSK and grayunmapPSK) which I have
included and must be uncommented(single comments only) and loaded into your workspace.
Remove the function calls from this m-file after you load into your
workspace.
It seems to work well and give valid results for BPSK and QPSK but I have a question
about the setup for 8PSK and the solution for Pseint where Pse=Pseint.
Also, the Gray coding seems different than what I m used to.
Some of you more theoretical minded may have some insight into the theory
behind how Pseint was determined and comment. I don t have the
communications toolbox-blockset and was wondering how it compared with Matlab s
example simulation of 8PSK with Gray coding (in Simulink?)
Each run takes about a minute and the loop iterations are shown in the
command window.
A numerical example of a satellite link is shown using uncoded QPSK )
- 2009-08-25 19:32:08下载
- 积分：1
