登录
首页 » matlab » Example4_1_1

Example4_1_1

于 2010-12-25 发布 文件大小:1KB
0 75
下载积分: 1 下载次数: 2

代码说明:

  Fourier Series example in Advanced Mathmatic for Engineer with matlab

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Matlabjijin
    讲解了一些最常用的例子并加以说明,从而更深入的了解(Explain some of the most common example is to illustrate to a better understanding of)
    2011-05-22 11:12:52下载
    积分:1
  • ARIMA
    MATLAB ARIMA 模型 做时间序列分析预测(MATLAB ARIMA )
    2014-11-24 09:39:24下载
    积分:1
  • 绘制出二维杂波功率谱图Rc16 8
    该程序利用空时二维自适应处理的原理,采用最优处理器的方法,对杂波矩阵进行处理,并能够绘制出二维杂波功率谱图,功率谱亮度图,特征谱图,二维频响图,以及最优化比较图(The program is the use of space-time two-dimensional adaptive processing principle, the optimal processor, clutter matrix processing, and be able to draw a two-dimensional clutter power spectrum, the brightness of the power spectrum diagram, characteristic spectra, two dimensional frequency response diagram, as well as the optimization Comparison)
    2013-04-02 20:35:22下载
    积分:1
  • dualband
    two-section dual-band Chebyshev impedance transformer
    2010-12-01 23:17:36下载
    积分:1
  • CWT2
    SAR图像二维小波gabor变换,读取SAR图像,并进行Gabor变换,求得最大值和次最大值(Gabor two-dimensional wavelet transform for SAR image.read the SAR image, and the Gabor transform to obtain the maximum and times the maximum)
    2012-04-16 19:04:04下载
    积分:1
  • ofdm-basic-principal
    运用matlab对ofdm的原理进行仿真,高效仿真验证ofdm的基本原理(ofdm basic principa)
    2012-05-18 10:49:33下载
    积分:1
  • sigma-delta-modulation
    高精度、低功耗模数转换器是当今集成电路设计模拟领域的研究热点之一,采用sigma-delta调制原理和过釆样原理的模数转换器广泛使用在音频、数字网络、电子测量等系统中。此类模数转换器,为降低信号带内的量化噪声功率,而釆用噪声整形技术,为提高模数转换器的信噪比,使用过采样技术,将基带中的量化噪声调制到了高频区域,这样就增加了基带中的信噪比,也就是增加了转换器的有效量化位数,由于采用较高的过采样率,Sigma-Delta ADC的转换速率相对较低,高精度和较低转换速率的特点,使得Sigma-Delta ADC特别适用于测量。(High precision, low power analog to digital converter is in today s integrated circuit design simulation has become one of the hot research field, the principle of sigma-delta modulation and ADC sampling principle is widely used in audio, digital network, electronic measurement system. This type of analog-to-digital converter, in order to reduce the quantization noise power signal in the band, and the use of noise shaping technique, in order to improve the SNR of the analog-to-digital converter, using the oversampling technique, modulate the quantization noise in the baseband to the high frequency region, which increases in the baseband signal to noise ratio, that is to increase the effective number of quantization bits converter, due to the sampling rate is high, the Sigma-Delta ADC conversion rate is relatively low, the characteristics of high accuracy and low conversion rate, so that Sigma-Delta ADC is especially suitable for measuring)
    2015-01-08 13:06:02下载
    积分:1
  • JGPC_CARIMA
    说明:  改进的广义预测控制,源码程序,适用于非最小相位系统的C(JGPC)
    2010-04-11 14:14:53下载
    积分:1
  • Tabular-method-procedures
    用表上作业法求解运输问题,基于matlab的算法实现(Tabular method procedures)
    2011-04-29 22:45:32下载
    积分:1
  • axi_master
    自己写的 AXI master code(AXI master code)
    2014-10-20 15:53:41下载
    积分:1
  • 696524资源总数
  • 103945会员总数
  • 46今日下载