-
espritgaijin
用MATLAB编写的TLS-ESPRIT算法，算法原理可参考张贤达版的现代信号处理，绝对可运行，程序配合书非常容易理解，而且稍微改改就可以变为基本的ESPRIT算法。(Written by MATLAB TLS-ESPRIT algorithm, the algorithm can refer to Zhang XD version of the principle of modern signal processing, absolutely can run the program with the book is very easy to understand, and can become a little change to change the basic ESPRIT algorithm.)
- 2010-12-29 21:16:10下载
- 积分：1
-
fh_mfsk
this is frequency hopping mfsk in matlab
- 2009-07-15 11:08:33下载
- 积分：1
-
LMS--matlab
LMS算法源程序，包括仿真，自适应陷滤波器，IIR滤波器等(LMS algorithm source, including simulation, adaptive notch filters, IIR filters, etc.)
- 2012-07-10 11:39:15下载
- 积分：1
-
QGA
说明： 本案例主要讲述新型遗传算法——两字遗传算法。量子遗传算法是量子计算和遗传算法的几何体，是一种概率进化算法。(This case is mainly about a new type of genetic algorithm-two-word genetic algorithm. Quantum genetic algorithm is the geometry of quantum computation and genetic algorithm, and it is a probabilistic evolutionary algorithm.)
- 2020-10-07 08:40:22下载
- 积分：1
-
SoftGNSS-original
说明： GNSS软件接收机，用于对中频信号的处理及导航定位解解算(GNSS Software receiver.It is used to process if signal and solve navigation and positioning.)
- 2021-04-19 19:28:51下载
- 积分：1
-
chengxu
2010年吉林省数学建模大赛A题matlab程序清单(Mathematical Modeling Contest in 2010 in Jilin Province matlab Listing A Question)
- 2010-12-13 16:49:21下载
- 积分：1
-
wind-power-prediction-
这是基于matlab的风功率预测模型及程序，与大家一起分享！(This is a matlab-based wind power prediction models and procedures, and to share with everyone!)
- 2021-04-24 14:38:47下载
- 积分：1
-
matlab
结合双线性变换法数字巴特沃斯高通IIR滤波器。能起到检波作用(Bilinear transformation method combined with digital high-pass Butterworth IIR filter. Can play a role in detection)
- 2011-01-15 17:38:38下载
- 积分：1
-
trns
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:45:44下载
- 积分：1
-
power_thermal
power_thermal.rar,功率电子领域matlab仿真文件，已经验证过，程序运行正常(power_thermal.rar,
Power electronics field matlab simulation file, has already been
verified, the normal operating procedures)
- 2013-07-14 12:51:24下载
- 积分：1
