登录
首页 » matlab » orientation

orientation

于 2011-01-05 发布 文件大小:1KB
0 80
下载积分: 1 下载次数: 3

代码说明:

  车牌定位:对侯选区域加以判别,侯选区域的判定可以利用车牌区域固有的特征来进行(License Plate Location: identification of candidate regions to be, to determine candidate regions of license plate can be used to carry out the inherent characteristics of)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Samplingfromadiscretedistribution
    说明:  MonteCarlo抽样Matlab程序(Sampling from a discrete distribution)
    2010-05-01 12:45:52下载
    积分:1
  • nonlinear-function-fitting-BP
    MATLAB工具箱编写BP神经网络的非线性系统用于非线性函数拟合(Written MATLAB toolbox for nonlinear systems BP neural network for nonlinear function fitting)
    2011-04-27 10:57:03下载
    积分:1
  • ABC_MATLAB_web
    人工蜂群算法的源代码,很好用,可以自己个别的修改下(Artificial bee colony algorithm source code, very good, and modifications can be their own individual)
    2012-11-24 12:06:20下载
    积分:1
  • danpao3
    matlab程序,地震数据单炮的模拟,震源为Ricker子波(matlab program to simulate the seismic data in a single shot, the source for the Ricker wavelet)
    2014-02-20 16:52:56下载
    积分:1
  • sousuo
    搜索算法是利用计算机的高性能来有目的的穷举一个问题的部分或所有的可能情况,从而求出问题的解的一种方法。( The searching algorithm has a goal exhaustion question part or all possible situations using computer s high performance, thus extracts the question the solution one method. )
    2011-04-21 08:47:11下载
    积分:1
  • Untitled
    edge detection using gabbis
    2013-11-16 19:26:40下载
    积分:1
  • FFT-abs
    对正弦信号进行傅里叶变换,并对比不同的信号长度与采样频率对结果的影响(Fourier transform of the sinusoidal signal and contrast the different length of the signal with the sampling frequency results)
    2013-04-12 10:02:35下载
    积分:1
  • uwb_TOA_positioning
    该程序可以实现基于TOA估计的异步UWB定位。其中包括卡尔曼滤波、LSE估计、采用高斯函数作为冲激脉冲等(The program can achieve asynchronous UWB TOA estimation based positioning. Including Kalman filtering, LSE estimation using Gaussian function as impulse, etc.)
    2014-05-08 12:02:25下载
    积分:1
  • Mobile-robot-tracking-of-pre-planned-paths-
    ............... Mobile robot tracking of pre-planned paths ..................................................................................................................
    2014-09-02 21:07:20下载
    积分:1
  • chap4
    .已知某炉温控制系统,要求温度保持在600℃恒定,针对该控制系统有以下控制经验: (1)若炉温低于600℃,则升压,低的越多升压越高; (2)若炉温高于600℃,则降压,高得越多降压越低; (3)若炉温等于600℃,则保持电压不变。 设模糊控制器为一维控制器,输入语言变量为误差,输出为控制电压。输入输出变量的量化等级为7级,取5个模糊集,试设计隶属度函数误差变化划分表,控制电压变化划分表和模糊控制规则表。 (Known for a temperature control system that requires a constant temperature is maintained at 600 ℃, the following control experience for the control system: (1) If the furnace temperature is below 600 ℃, the step-up, the more the higher the lower the boost (2) if the furnace temperature is higher than 600 ℃, the blood pressure, high blood pressure, the lower the more (3) If the furnace temperature is equal to 600 ℃, then keep the voltage constant. Set of fuzzy controller for one-dimensional controller, input linguistic variables for error, the output control voltage. Input and output variables of quantization levels for seven, take five fuzzy sets, membership function test design error variance divided table, partition table and the control voltage variation fuzzy control rule table.)
    2015-04-10 21:53:18下载
    积分:1
  • 696524资源总数
  • 103930会员总数
  • 47今日下载