登录
首页 » matlab » Principles_of_Communication_Systems_Simulation_wit

Principles_of_Communication_Systems_Simulation_wit

于 2011-01-06 发布 文件大小:6620KB
0 162
下载积分: 1 下载次数: 21

代码说明:

  《通信系统仿真原理与无线应用》系统地介绍通信系统的设计、分析和仿真方法,还提供了大量极具参考价值的仿真实例。《通信系统仿真原理与无线应用》的全部仿真程序都是采用MATLAB编写的。这不仅方便读者理解仿真的实现过程,还允许读者修改或使用这些代码段来进行自己的仿真开发。章后提供了大量的参考文献和经过精心设计的各类练习题,方便教学。 此为英文原版书籍(Principles of Communication Systems Simulation with Wireless Applications is a hands-on, example-rich guide to simulating wireless communications systems. The first book to present complete MATLAB simulation models for predicting the impact of design changes, it treats every aspect of simulation: sampling, signal and system representations, filters, noise, Monte Carlo simulation, postprocessing, nonlinear and time-varying systems, waveform and discrete channels, co-channel interference, and more. It includes four detailed case studies.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • SVMxianxing
    基于标准支持向量机对传感器的线性系统用MATLAB软件进行仿真建模程序(Based on the standard support vector machine (SVM) of the linear system of sensor with the MATLAB software simulation modeling procedures )
    2012-04-15 20:02:26下载
    积分:1
  • huffman
    在matlab中实现哈夫曼压缩和解压缩。(Huffman compression and decompression in matlab.)
    2013-12-04 16:01:36下载
    积分:1
  • anli21.5-4
    北京航空航天大学出版的matlab从零进阶的原程序代码第1章案例21.4源代码(Beijing University of Aeronautics and Astronautics from zero Advanced matlab published the original program code in Chapter 1 Case 21.4 source code)
    2014-01-17 21:48:01下载
    积分:1
  • sensorless_MRAS_svpwm
    基于模型参考自适应空间矢量调制的永磁同步电机矢量控制(model reference adaptive control,svpwm,PMSM,foc)
    2010-08-27 11:11:56下载
    积分:1
  • fbg-reflection-spectra
    用matlab模拟均匀光纤布拉格光栅的反射谱(use matlab to simulate fiber bragg grating reflection spectra)
    2013-01-05 22:14:48下载
    积分:1
  • PSNR_Metric
    This is a matlab implementation for calculating PSNR
    2009-04-20 17:45:15下载
    积分:1
  • matlab--face-emotion-detection
    facial emotion using matlab
    2014-10-28 02:12:49下载
    积分:1
  • Blind-identification
    利用现代谱估计中的AR 模型求取仿真噪声信号和真实噪声信号的模型参数,然后利用这些参数求得信号的功率谱图,通过功率谱图定性地描述主噪声源和次噪声源。在利用信号功率谱图定性描述噪声源后,进一步地利用曲线相似度和曲线关联度定量的识别主噪声源和次噪声源(Use of modern spectral estimation of AR model to strike a realistic simulation of the noise signal and noise model parameters, and then use these parameters obtained by the signal power spectrum, power spectrum qualitatively described by the main noise source and the second noise source. In the use of qualitative description of the noise signal power spectrum of the source, the further use of the correlation curve and the curve of quantitative similarity identification of the main noise source and the second noise source)
    2011-11-20 22:07:43下载
    积分:1
  • three_dim_plot
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:56:06下载
    积分:1
  • jml-tutorial
    it is PDF for How to write the right JML for our code.. Very Helpful for new users
    2014-10-30 04:10:19下载
    积分:1
  • 696518资源总数
  • 106161会员总数
  • 5今日下载