登录
首页 » matlab » Codeur

Codeur

于 2011-01-17 发布 文件大小:178KB
0 217
下载积分: 1 下载次数: 81

代码说明:

  relay cooperation and decode and forward

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • MatlabFns.tar
    matlab的一些函数功能,方便用户各自要求进行选择。(some function matlab function to facilitate the users to choose their own requirements.)
    2009-01-21 11:14:06下载
    积分:1
  • tendency
    关于线性非线性趋势项去除方法的研究及总结(Items on the linear non-linear trend removal method of research and summary)
    2010-01-19 12:27:14下载
    积分:1
  • source_gen
    wcdma标准,产生单载波matlab信号源,设定任意帧长(the wcdma standards, resulting in single-carrier Matlab source, set any frame size)
    2012-03-24 15:40:39下载
    积分:1
  • scriptbpsk
    communication system 2
    2012-06-24 14:42:46下载
    积分:1
  • Code_bpnn
    Magnus Norgaard s NEURAL NETWORK BASED SYSTEM IDENTIFICATION TOOLBOX Version 1.1 Department of Automation Building 326 2800 Lyngby, Denmark Technical University of Denmark
    2011-12-29 15:37:28下载
    积分:1
  • DSP_3_17_3
    产生随机信号观测样本,不同信噪比和归一化频率。用Leivison-Durbin迭代算法求解AR模型的系数并估计功率谱。(Generate random signal observation samples, different signal to noise ratio and normalized frequency.Use Leivison- Durbin iterative algorithm of AR model coefficients and estimate the power spectrum.)
    2015-04-10 17:57:04下载
    积分:1
  • 基于有限差分法的二维边值问题的数值分析
    1. 在matlab中分析基于分离变量法的解析解; 2. 利用简单迭代法求解,与解析法结论对比,分析求解结果的精确度。分析过程至少包括:在网格尺寸为0.1 m和1 m两种条件下,两次迭代差值最大为10-10时的分析结论; 3. 利用超松弛迭代法分析,选择松弛因子,分析其对收敛速度(即迭代次数)的影响,并确定最优值。分析过程至少包括:在网格尺寸为0.1和1两种条件下,两次迭代差值最大为10-10时,迭代次数随松弛因子的变化,得到对应的最优松弛因子,与经验值(课本165页式子3.7.15)进行对比。(1. Analyze the analytical solution based on the separation variable method in matlab. 2. Using a simple iterative method to solve, compared with the results of the analytical method to analyze the accuracy of the solution. The analysis process at least includes the following conclusions: when the mesh size is 0.1m and 1m, the maximum difference between two iterations is 10-10. 3. Analyze using the relaxation relaxation iteration method, select the relaxation factor, analyze its influence on the convergence speed (ie the number of iterations), and determine the optimal value. The analysis process at least includes the following: when the mesh size is 0.1 and 1 and the maximum difference between two iterations is 10-10, the number of iterations varies with the relaxation factor, and the corresponding optimal relaxation factor and empirical value are obtained ( Textbook 165 pages (3.7.15) for comparison.)
    2020-07-28 18:48:39下载
    积分:1
  • Shock-Filters
    利用Shock Filters去除图像噪声,附件里有关于Shock Filters的网页介绍(use Shock Filters remove image noise, annex on the Shock's website on Filters)
    2007-05-24 17:35:08下载
    积分:1
  • Electric-Wheelchair-Demo
    An electric wheelchair uses a motor with a torque constant of 1.1 Nm/A, powered from a 24 V battery, with an internal resistance of 0.25Ω. We are interested in designing a controller with 44 Nm continuous torque capability, both in driving and braking modes at all speeds, with the widest possible operating speed range, both forward and reverse direction using the given battery.
    2012-06-25 20:38:58下载
    积分:1
  • Occam1DCSEM
    海洋可控源一维反演程序,用于进行数值模拟以及实测数据处理(The program is used to calculate the forward responses and to invert the measured data)
    2021-04-06 14:29:02下载
    积分:1
  • 696516资源总数
  • 106554会员总数
  • 12今日下载