登录
首页 » MultiPlatform » startup

startup

于 2008-08-11 发布 文件大小:2KB
0 124
下载积分: 1 下载次数: 44

代码说明:

  Keil uVision3例证代码NOMOD51 This file is part of the C51 Compiler package Copyright (c) 1988-2005 Keil Elektronik GmbH and Keil Software, Inc. Version 8.01(Keil uVision3 example code NOMOD51This file is part of the C51 Compiler package Copyright (c) 1988-2005 Keil Elektronik GmbH and Keil Software, Inc. Version 8.01)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • test1
    基于STC89C51的红外解码程序,并且在数码管显示(STC89C51 based infrared decoding procedures, and in the digital display)
    2013-09-02 23:54:43下载
    积分:1
  • Carrier_0_03.tar
    CARRIER todo esto es un documento elaborado con la mayora facilidad
    2013-12-14 04:43:26下载
    积分:1
  • lab7-LCD
    说明:  dab单环控制,基于输出电压闭环和DSP28335,以及显示器(single closed loop controller of DAB)
    2019-07-10 12:55:45下载
    积分:1
  • Ctrl-par-picoscope
    This software is an example to use Picoscope 3306 DC generator to drive an old Heater.
    2015-06-04 22:39:19下载
    积分:1
  • digital-voltmeter
    基于51单片机,adc0809,lcd1602的数字电压表protues仿真和c源程序代码(Based on 51 single-chip, adc0809, lcd1602 digital voltmeter protues simulation and c source code)
    2013-03-28 21:27:49下载
    积分:1
  • SQL
    can kao shouce (can kao shou ce )
    2013-12-23 17:21:08下载
    积分:1
  • E931.96
    本文档基于 E931.96 运动检测控制器和 LHI968 被动红外探头设计被动红外,采用的板 子为 ZLG APL_PIR V1.00,控制器为 LPC1114,开发环境为 Keil。(This document is designed based on a passive infrared motion detection controller E931.96 and LHI968 passive infrared sensor, using the board as ZLG APL_PIR V1.00, controller LPC1114, development environment for Keil.)
    2020-10-12 23:27:32下载
    积分:1
  • DMA+多路ADC+定时器+均值滤波
    基于stm32f103的多路ADC采集,将采集的电压传入到DMA设定的内存中,在通过均值滤波得到比较准确的数据(Based on the multi-channel ADC acquisition of stm32f103, the collected voltage is transferred to the memory set by DMA, and the more accurate data are obtained by means of mean filter.)
    2020-06-21 11:00:02下载
    积分:1
  • lesson9_1
    在51开发板上,向AT24C02 EEPROM中写入0x(xx),同时读出之后赋值给P1口。注意三处加*********(In the 51 development board, write 0x (xx)to AT24C02 EEPROM , while after reading assigned to P1 port. Note that three plus。)
    2013-07-19 17:20:46下载
    积分:1
  • move
    智能车接收上位机发送的指令,完成相应移动,包含三步,旋转、前进/后退、再旋转( U667A u80FD u8F66 u63A5 u6536 u4E0A u4F4D u673A u53D1 u9001 u7684 u6307 u4EE4 uFF0C u5B8C u6210 u76F8 u5E94 u79FB u52A8 uFF0C u5305 u542B u4E09 u6B65 uFF0C u65CB u8F6C u3001 u524D u8FDB / u540E u9000 u3001 u518D u65CB u8F6C)
    2017-03-28 20:14:00下载
    积分:1
  • 696518资源总数
  • 105722会员总数
  • 0今日下载