-
smoke
This project is under Digital image processing. The project helps us to identify the smoke present in the images, the source code is written by matlab scripting.
- 2009-10-03 22:03:13下载
- 积分：1
-
apple
根据静态苹果图像RGB三值检测苹果表面是否有缺陷，比较准确(Apple RGB image from the static three-valued test whether apple surface defects, more accurate)
- 2011-05-10 17:00:56下载
- 积分：1
-
TP2SM56
This paper review the effectiveness of the parity space approach
to identify faults or disturbance in a system. The most commonly
used is the observer based procedures, and redundancy relationship
method. This involves analytical mathematical analysis of
geometry and bilinear algebra. Then, technological advances which
require complex computation such as artificial intelligence and
genetic algorithm had made tremendous improvement to fault
Detection and Isolation (FDI) analysis. Dynamic Parity Space
Approach was studied for a discrete state-space model. Important
data will be extracted using this approach especially for residual
generation which is the backbones of FDI analysis. Subsequently,
at each time instant k, the generated residuals will form a matrix
that will define the fault signature. It is remarkable that this
approach is proven in this study to be effective in diagnosis and
faults isolation.
- 2012-06-09 19:43:00下载
- 积分：1
-
SMI
仿真SMI（DMI）算法性能，观察采样快拍数对波束图的影响、接收信号中不包含、包含信号功率逐渐加大对波束图的影响(Simulation SMI (DMI) algorithm performance, the number of snapshots observed sampling effects on the beam diagram, the received signal does not contain, include the gradual increase of the signal power of the beam map)
- 2011-08-17 09:47:50下载
- 积分：1
-
1---Copy-(2)
In such situations, the performance of Monte Carlo simula-
tions may be better: they are faster and there are no limitations
for the number of components in simultaneous outages.
- 2013-05-06 01:44:47下载
- 积分：1
-
stft
对信号进行短时傅立叶变换以及Wigner-Ville分布分析的matlab程序(The signal short-time Fourier transform and Wigner-Ville distribution analysis matlab program)
- 2009-04-09 22:48:43下载
- 积分：1
-
short-circuit
这个说明倒不是说明函数的功能，只是声明一下函数中出现的问题。
shortest()函数没有问题，在secshortest中我希望只得到一条次短路（或几条roadcost()值相同的次短路），结果却出来好几条，我仔细检查了一下程序，应该没有什么问题。
因此在使用时，要得到次短路，只能用roadcost()函数分别求一下各条路的权重和，找到最小的。
有些奇怪
(Note that this is not the function of function, but a statement about the problems in function. shortest () function there is no problem, I hope that in secshortest only a short time (or several roadcost () times the value of the same short-circuit), the result is several out, I carefully examined the process, it should be no problem. Therefore, in use, to be at a short circuit can only be used roadcost () function, respectively, for some of the weight of the road and find the smallest. Some strange)
- 2009-05-21 21:11:51下载
- 积分：1
-
bpsk
BPSK信号的仿真，解调，仿真结果误码率计算(BPSK signal simulation, demodulation, bit error rate simulation results)
- 2008-06-27 20:42:17下载
- 积分：1
-
tsp
tsp problem, nn algorithm
- 2012-04-02 18:51:59下载
- 积分：1
-
ENVELOPE_gets_the_data_of_upper_and_down_envelope_
获取已知输入信号的上、下包络的matlab程序(ENVELOPE gets the data of upper and down envelope of the known input signal)
- 2009-09-28 14:29:49下载
- 积分：1
