登录
首页 » matlab » mcode

mcode

于 2010-04-02 发布 文件大小:1KB
0 135
下载积分: 1 下载次数: 0

代码说明:

说明:  AM调制解调仿真,调幅度测量,不含干扰 (AM Modulation and Demodulation, transfer rate measurement, without interference)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论


0 个回复

  • FEMproject1
    固体力学的大作业,有限元法计算阶段梁,包括了计算单元应力。(Finite Element Method matlab program, an example of 1D step beam element. Including calculation of elemental stress.)
    2010-06-11 03:59:37下载
    积分:1
  • find_minium
    matlab优化程序,简单易用,极大提高工作效率。(matlab optimization procedures, easy to use, greatly enhancing efficiency.)
    2007-11-27 11:10:59下载
    积分:1
  • text2
    离散随机信号的计算机仿真(验证性实验)---仿真协方差函数为C(x)的高斯过程(Computer simulation of discrete stochastic signal validation experiments--- Simulation covariance function C (x) of the Gaussian process)
    2012-11-01 23:59:27下载
    积分:1
  • ADRC
    ADRC的主程序。包括跟踪微分器,扩张状态观测器以及非线性反馈环节的程序(ADRC main program. A program for tracking a differential device, an extended state observer and a nonlinear feedback link)
    2020-12-13 23:39:15下载
    积分:1
  • GFCM
    FCM algorithm optimisation by genetic algorithm
    2014-08-25 21:28:14下载
    积分:1
  • 10.1.1.193.161
    国外的一篇关于飞行器滑模控制的文章,写的比较好,对我启发比较 (Abroad an aircraft sliding mode control article, write better, I am inspired comparison)
    2013-04-09 22:08:37下载
    积分:1
  • router
    A simple router modeled in MATLAB s Stateflow. Can be simulated and linked to analyze traffic flow and communication.
    2012-02-14 06:14:11下载
    积分:1
  • three_dim_plot
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:56:06下载
    积分:1
  • Untitled5
    2PSK和 2DPSK信号的调制与解调性能比较分析 基于matlab的仿真(Comparative analysis of modulation and demodulation performance and 2DPSK signal 2PSK)
    2013-11-23 15:55:45下载
    积分:1
  • matlab-H
    matlab处理图像代码,很不错,值得看看(matlab image processing code, very good, worth a look)
    2013-11-15 16:45:28下载
    积分:1
  • 696518资源总数
  • 104887会员总数
  • 24今日下载