-
addmusic
在matlab的环境下，运行此程序可将两段音频信号进行叠加(In the matlab environment, run this program can be two audio signals are superimposed)
- 2009-12-16 14:40:49下载
- 积分：1
-
ga
说明： 介绍如何在matlab环境下开发遗传算法(introduction to ga arithmatic based on matlab)
- 2012-05-22 22:56:26下载
- 积分：1
-
outage
The outage probability calculation for awgn channel
- 2015-03-20 22:15:06下载
- 积分：1
-
impmet
IMPMET Standard impedance matrix (metal surface)
Returns the complex impedance matrix [EdgesTotal x EdgesTotal]
Uses 9 integration points for every triangle (barycentric subdivision)
The impedance matrix is calculated as a sum of the contributions due to separate triangles (similar to the "face-pair" method).
- 2010-06-21 07:35:06下载
- 积分：1
-
inverse
Matrix inverse by Gauss-Jordan elimination
- 2010-03-06 17:21:56下载
- 积分：1
-
simulation
对异常声音做时延的模拟，并得出四个模拟麦克风接收的音频信号。(On the unusual sound of analog delay to do, and come to the microphone to receive the four analog audio signals.)
- 2010-05-17 21:39:07下载
- 积分：1
-
IIR_A_FIR_Weiner
Source code for Adaptive IIR_FIR_Weiner Filter
- 2014-11-28 07:15:58下载
- 积分：1
-
mandelbrot
This guide can draw a mandelbrot figure. In default values it calculates Z=Z^2+C for 20 iterations, where Z initally equal to zero and C has the values of every pixel created by meshgrid function(built-in).
although mandelbrot equation is Z=Z^2+C you can change the degree of the equation between 1 - 50.
higher number in iteration, points in axes gives better results in image besides more resulting time.
to zoom an area of the figure you must aproximately choose the point and then change the center values to this point values then push Show Graph button. because of this is the first version there can be any lack of usage.
(This guide can draw a mandelbrot figure. In default values it calculates Z=Z^2+C for 20 iterations, where Z initally equal to zero and C has the values of every pixel created by meshgrid function(built-in).
although mandelbrot equation is Z=Z^2+C you can change the degree of the equation between 1- 50.
higher number in iteration, points in axes gives better results in image besides more resulting time.
to zoom an area of the figure you must aproximately choose the point and then change the center values to this point values then push Show Graph button. because of this is the first version there can be any lack of usage.
)
- 2010-02-17 07:21:59下载
- 积分：1
-
EtherCAT-Slave-Stack-Code-Tool
slave stack code tool
- 2015-03-18 10:49:02下载
- 积分：1
-
MATLABfangzhen
《系统辨识与MATLAB仿真.pdf》 侯媛彬 汪梅 王立琦
本书共分8章，第1、2章为辨识的基本概念、理论基础和古典辨识方法；第3至6章为现代辨识内容，其中第3章是最小二乘参数辨识，第4章是梯度校正参数辨识，第5章是极大似然法的参数辨识方法，第6章是自适应参数辨识；第7、8章为复杂的非线性系统的智能辨识和混沌辨识，其中第7章是非线性系统的神经网络辨识；第8章是Volterra辨识方法、复杂系统的混沌现象及其辨识。从第2至7章，各章均包含开发的相应程序及其程序剖析。
(" System Identification and MATLAB simulation. Pdf" Hou Yuanbin Wang Mei Wang Liqi book is divided into eight chapters, Chapters 1 and 2 for the identification of the basic concepts, theoretical foundation and classical identification methods first 3-6 chapters of modern identification content, Chapter 3 is the least squares parameter identification, Chapter 4 is the gradient correction parameter identification, Chapter 5 is the maximum likelihood parameter identification method, Chapter 6 is an adaptive parameter identification Chapters 7 and 8 for complex Intelligent identification of nonlinear systems and chaos identification, which is in Chapter 7 of the neural network nonlinear system identification Chapter 8 is Volterra identification method, complex systems and chaos identification. From the first 2-7 chapters, each chapter contains procedures for the development of appropriate programs and their analysis.)
- 2013-06-04 14:28:55下载
- 积分：1
