登录
首页 » matlab » cdma

cdma

于 2011-03-23 发布 文件大小:2KB
0 204
下载积分: 1 下载次数: 0

代码说明:

说明:  CDMA仿真系统 Gold码族 最佳接收机 (the cdma system simulation)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • KalmanAll
    说明:  matlab中的kalman滤波工具箱;解压后请置于toolbox目录下,添加addpaht(genpath( 路径 ))。 (of Matlab Toolbox Kalman filtering; please unpacked placed toolbox directory, add addpaht (genpath (path)).)
    2006-01-09 08:28:52下载
    积分:1
  • Neuralnetwork
    说明:  MATLAB与神经网络,内涵工具箱应用,基于初级理论的神经网络。(MATLAB and the neural network, the application of the connotation of the toolbox, based on the primary neural network theory.)
    2009-08-19 09:49:49下载
    积分:1
  • matlabbook
    说明:  哈工大matlab 讲义 希望对大家有用 对于刚开始学的有作用(HIT matlab useful handouts hope for all of us are just beginning to learn about the role of)
    2008-11-23 16:21:29下载
    积分:1
  • shishangbailicongshuexam100gui
    解非线性方程组的gui程序,选自机械工业出版社出版的《时尚百例丛书》(solving nonlinear equations of gui procedures, industrial machinery from the publishing house "Fashion 100 cases Series")
    2007-05-30 08:32:01下载
    积分:1
  • tiaopin
    分析并实现了跳频信号的检测方法,用程序给出仿真结果(Analysis and implementation of frequency hopping signal detection method, using the program simulation results)
    2013-09-01 15:33:40下载
    积分:1
  • sys
    地震合成记录,通过褶积模型,利用子波和反射系数求出了自激自收情况下的波形。(synthetic seismogram)
    2011-12-06 16:34:27下载
    积分:1
  • 项目4
    说明:  任务:设计一个4×2.5Gbit/s 长距离光纤传输系统,并利用OptiSystem 仿真验证。 要求: 1.采用波分复用技术,波长设置以100GHz 为间隔,频率分别为193.1THz、193.2THz、193.3THz、193.4THz,每个波长传输速率为2.5Gbit/s(NRZ),传输距离为300km。采用常规光纤,光纤损耗系数为0.25dB/km。 2.单通道光发送机最大输出功率为0dBm,光接收机的接收光功率不低于-26dBm,过载点为-10dBm。 3.可以采用EDFA 作为线路放大器,其中EDFA 的输入功率限制在-18~2dBm,最大输出功率20dBm,增益范围为13~25dB,噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)
    2019-05-13 09:39:41下载
    积分:1
  • 粒子
    说明:  各种粒子群优化算法,免疫粒子群优化算法,混沌粒子群算法(Various particle swarm optimization algorithms, immune particle swarm optimization algorithm, chaotic particle swarm optimization algorithm)
    2021-04-11 10:48:58下载
    积分:1
  • IEEEMatlab
    MATLAB:A Tool for Algorithms Development and System Analysis
    2010-11-19 15:59:57下载
    积分:1
  • jun7
    这是关于dsttd自适应调制的非常好的一片文章(dsttd adaptive modulation on the article a very good)
    2007-04-20 18:16:44下载
    积分:1
  • 696516资源总数
  • 106913会员总数
  • 8今日下载