登录
首页 » LabView » xuniwenduji

xuniwenduji

于 2010-05-04 发布 文件大小:89KB
0 173
下载积分: 1 下载次数: 5

代码说明:

说明:  本论文的目的是产生虚拟温度计,利用labview语言设计程序,并采用神经网络技术进行拟合,从而实现对温度的测量 (The purpose of this paper is to produce a virtual thermometer, using labview language design process, and were fitted using neural network technology, enabling the measurement of temperature)

文件列表:

虚拟温度计.doc

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • stm32 st7789 320240驱动
    说明:  st7789 320240 TFT液晶驱动 for stm32(st7789 320240 drive for stm32)
    2020-08-19 11:10:40下载
    积分:1
  • keyboard
    该程序是基于51单片机的矩阵键盘程序,单片机采用对键盘行列分别扫描的方法,实现按键的检测。(The program is 51 microcontroller-based matrix keyboard program the microcontroller using the method of scanning the keyboard ranks to achieve the detection of key.)
    2012-02-04 20:29:40下载
    积分:1
  • LESSON1_0_LED
    stm32f10xc8t6点亮LED灯在代码(light the leds for stm32f10xc8t6)
    2017-04-08 19:45:18下载
    积分:1
  • s
    说明:  无线通信接受模块程序,内含数模转换应用程序。(Wireless receiving module program that includes digital to analog conversion applications.)
    2011-07-20 09:29:11下载
    积分:1
  • dds
    51单片机实现简易函数信号发生器功能(正弦波、方波、三角波)(51MCU,sin ,pluse,and so on)
    2011-12-03 12:57:27下载
    积分:1
  • stm32f4_urat
    stm32f4串口通信,STM32F4与STM32F1在ADC方面的区别(stm32f4 usart)
    2012-12-14 15:24:09下载
    积分:1
  • Blank
    说明:  STM32F103ZET6移植官方RT-Thread嵌入式操作系统框架(STM32F103ZET6 Porting Official RT-Thread Embedded Operating System Framework)
    2020-06-16 02:00:01下载
    积分:1
  • Phase-Difference
    STM32单片机,采用数字相关法测量两路波的相位差,内含工程,进行了模拟数据测试通过,稍微修改即可使用,并附上了理论文档。(STM32 microcontroller, using digital Correlation Method for Measuring the phase difference between two waves, including engineering, tested by simulated data, you can use slightly modified, with a theoretical document.)
    2021-04-18 12:28:52下载
    积分:1
  • baohu2
    用于了解分布式电源涉及配电网保护的相关问题。(Used to understand the issues related to the protection of distribution network.)
    2016-10-31 10:25:02下载
    积分:1
  • 交通灯控制
    说明:  包含proteus仿真文件及c语言程序,在开发板上进行过运行。利用双色LED显示电路,和四位静态数码管显示电路模拟十字路口交通信号灯。4位LED数码管显示时间,双色LED灯显示红绿灯状态。熟悉交通信号灯控制逻辑。设计一个十字路口的交通灯控制电路,要求南北方向和东西方向两个交叉路口的车辆交替运行。每次绿灯变红灯时,要求黄灯先亮3S,才能变换运行车辆。东西方向、南北方向车道除了有红、黄、绿灯指示外,每一种灯亮的时间都用数码管显示器进行显示(采用倒计时的方法)。考虑到特殊车辆情况,设置紧急转换开头。(It contains proteus simulation file and C language program. It has been run on the development board. Two-color LED display circuit and four-bit static digital tube display circuit are used to simulate traffic lights at intersections. Four-bit LED digital tube display time, two-color LED lights show the status of traffic lights. Familiar with traffic signal control logic. Design a traffic light control circuit at the intersection, which requires the vehicles running alternately in the north-south direction and the East-West direction. Every time the green light turns red, the yellow light is required to turn on 3S before changing the running vehicle. In addition to the red, yellow and green lights in the east-west and North-South lanes, the time of each kind of light is displayed by digital tube display (countdown method). Considering the special vehicle situation, set up the emergency switch start.)
    2020-06-17 13:40:02下载
    积分:1
  • 696518资源总数
  • 105885会员总数
  • 31今日下载