登录
首页 » matlab » conjgrad

conjgrad

于 2006-06-03 发布 文件大小:2KB
0 160
下载积分: 1 下载次数: 145

代码说明:

  共扼梯度法的Matlab源程序,寻找非线性或线性方程的极值(conjugate gradient method of Matlab source to find nonlinear equations or linear Extreme)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • FDTD_microstrip
    分享一个外国人编写的FDTD程序,可以用来计算微带线和微带贴片天线,程序中采用的是均匀网格划分,但也可以在容易地在它基础上改写成非均匀网格.其边界条件与Sheen的程序不同,这里采用二阶技术.(Prepared to share a foreigner FDTD procedures, can be used to calculate the microstrip lines and microstrip patch antenna, the procedure used is uniform mesh, but can also easily rewrite it into the basis of non-uniform grid. its boundary conditions with different processes and Sheen, where second-order technology.)
    2020-12-07 16:39:22下载
    积分:1
  • high-resolution-one-dimension
    高分辨率要求系统具有大的带宽,瞬时带宽的增加必将提高系统对硬件的要求,本文采用方便灵活的步进频率波形信号。脉间频率步进波形通过子脉冲载频的步进变化来获得大的有效带宽,使成像具有高分辨率,采用加窗和补零方法提高信噪比,但该信号对目标径向速度非常敏感。采用补零方法提高距离取样分辨率,使距离像细化,并用公式说明了补零只能提高距离取样分辨率,并不能改变频率步进信号的距离分辨能力。该信号波形对目标径向速度的敏感,使目标能量分散到邻近的距离单元造成距离分辨率下降,如果不事先进行速度补偿,直接对回波信号进行逆傅立叶变换,将使所成一维距离像发生频谱展宽,并伴有距离像发生平移。本文证明了当目标有径向速度时仍采用对回波信号直接进行逆傅立叶变换的方法将使一维距离像发生频谱展宽并伴有距离像发生频移,从而严重影响了一维距离像的质量。(high-resolution requirements of the system with large bandwidth, the increased instantaneous bandwidth will improve the system of hardware, In this paper, a flexible and convenient step frequency signals. Pulse frequency step-pulse waveform through the carrier frequency step to achieve great changes in the effective bandwidth. make imaging with high resolution, increasing the window and fill methods to improve signal-to-noise ratio is, However, the signal on the target radial velocity is very sensitive. Using zero-distance sampling method to improve resolution, so that distance as refinement, and formulates a zero-distance sampling can improve resolution, does not alter the frequency of the signal from stepping resolution capabilities. The signal waveform on the target radial velocity sens)
    2007-04-07 22:15:33下载
    积分:1
  • SRFTMATLAB-master
    滤波器与匹配电路的设计,基于简化实频技术的matlab实现(the SRFT achieves an optimal lter design byusing computer-aided optimization. This code will describe SRFT and a MATLABR implementation of the SRFT currently under development)
    2017-05-05 22:15:16下载
    积分:1
  • Moving-Least-Square-Method
    用于多学科设计优化中代理模型技术,移动最小二乘法是代理模型方法的一种(For multidisciplinary design optimization in the agent model, the moving least squares method is a kind of agent model)
    2020-11-12 09:39:43下载
    积分:1
  • APdL-ANSYS
    说明:  APdL参数化有限元分析技术及其应用实例(APdL parameterized finite element analysis techniques and its application)
    2011-04-14 09:37:44下载
    积分:1
  • pca_ica
    说明:  独立分析 主成分分析 可以提取矩阵独立成分与主成分,显示空间特征与时间特征以及对应的奇异分析用于计算能进行奇异值分解等。主要用于数值的提取计算等。(It can extract the independent and principal components of matrix, display the spatial and temporal characteristics, and use the corresponding singular analysis to calculate the singular value decomposition. It is mainly used for extraction and calculation of numerical value.)
    2020-04-15 22:00:02下载
    积分:1
  • 1parallel
    用于FLUENT计算结构单自由度涡激振动,采用四阶龙哥库塔法,并设置了并行计算(FLUENT, VIV, Fourth order Runge-Kutta )
    2016-09-30 18:49:07下载
    积分:1
  • SMUSIC
    单次快拍 MUSIC 算法,这种单次快拍 MUSIC 算法仅利用接收的一次快拍的 M(M 为阵元数)个数据,通过对这 M 个数据做统计处理,来估计阵列数据的协方差矩阵(Single snapshot MUSIC algorithm, this single snapshot the MUSIC algorithm only receiving a snapshot M (M array element number) data, statistical treatment of these M data to estimate the array data co covariance matrix)
    2020-09-09 22:18:06下载
    积分:1
  • ErosionTabakoff
    用于拓展fluent磨损模型的UDF,采用tabakoff经验公式描述磨损量。(a udf to optimize erosion model in Fluent)
    2021-03-05 17:19:31下载
    积分:1
  • Montecarlo_SNR
    用牛顿迭代法估计正弦信号的幅度,相位,频率,选用多次montecalor算法估计参数均值,并与理论上参数估计的CRLB下限进行比较。(Newton iterative method estimates the sinusoidal signal amplitude, phase, frequency, use multiple montecalor algorithm to estimate the parameters mean, and with the theoretical limit of parameter estimation CRLB compare.)
    2021-03-01 11:29:35下载
    积分:1
  • 696518资源总数
  • 106215会员总数
  • 5今日下载