-
Matlab-curve-fitting-program
Matlab曲线拟合程序，详细描述了CFtool工具使用方法及各种曲线拟合常用程序代码(Matlab curve fitting program)
- 2012-05-25 10:42:50下载
- 积分：1
-
Intro_to_DSP___Smith___Mersereau_ver._3.0
MatLab Solutions: Introduction to Digital Signal Processing: A Computer Laboratory Textbook .
- 2014-11-27 13:19:07下载
- 积分：1
-
ukf
无痕迹卡尔曼滤波器matlab应用程序，用于非线性系统滤波(No traces of the Kalman filter matlab application for a new system filtering)
- 2012-10-19 19:02:24下载
- 积分：1
-
共轭梯度法
说明： 用精确线搜索的共轭梯度法，求问题的极小点(Using the conjugate gradient method of exact line search to find the minimum point of the problem)
- 2021-01-08 10:13:10下载
- 积分：1
-
Moracevasobel
车辆特征提取 小波轮廓检测和Moracev焦点检测的功能融合(Vehicle contour detection and feature extraction of wavelet features Moracev focus detection integration)
- 2011-05-19 19:59:51下载
- 积分：1
-
Radar1
模拟雷达的一个小程序，扫面线周期性扫描，显示检测出来的异常点(A small program to simulate the radar sweep noodles periodic scanning, display anomalies detected point)
- 2014-10-17 16:00:47下载
- 积分：1
-
matlab_baogao
自己学习matlab时做的课程试验
内容：试验报告和灰度图像的线性非线性展宽(Matlab when you learn to do the pilot courses : the test report and a linear gray-scale image nonlinear wide)
- 2007-04-27 01:00:24下载
- 积分：1
-
409417080235
1．熟悉matlab基础操作。
2．能够用Lagrange插值, Newton插值法对函数表进行一次、二次、三次插值，体会各种插值方法不同的特点。
(A. Familiar with matlab underlying operating. Two. With Lagrange interpolation, Newton interpolation function table once, quadratic, cubic interpolation, and appreciate the different characteristics of the various interpolation methods.)
- 2012-06-11 10:36:44下载
- 积分：1
-
EM
说明： EM算法的matlab实现,经过测试可以运行(EM in matlab)
- 2014-08-12 21:25:46下载
- 积分：1
-
power_brushlessDCmotor
A three-phase motor rated 1 kW, 500 Vdc, 3000 rpm is fed by a six step voltage inverter. The inverter is a MOSFET bridge of the SimPowerSystems™ library. A speed regulator is used to control the DC bus voltage. The inverter gates signals are produced by decoding the Hall effect signlas of the motor. The three-phase output of the inverter are applied to the PMSM block s stator windings. The load torque applied to the machine s shaft is first set to 0 and steps to its nominal value (11 N.m) at t = 0.1 s.
Two control loops are used. The inner loop synchronises the inverter gates signals with the electromotive forces. The outer loop controls the motor s speed by varying the DC bus voltage.
- 2011-10-19 22:21:07下载
- 积分：1
