登录
首页 » matlab » IdealLowPassFilterusingDFT

IdealLowPassFilterusingDFT

于 2007-04-24 发布 文件大小:169KB
0 146
下载积分: 1 下载次数: 70

代码说明:

  采用离散傅立叶变换实现的低通滤波器,希望对你们有用,MATLAB实现(discrete Fourier transform of the low-pass filter, and I hope to you useful MATLAB)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • keystone
    当目标高速运动时,用keystone算法校正距离走动,本程序给出了keystone算法程序(keystone transform can correct the envelop migration,the program gives the the keystone algorithm program)
    2021-04-27 09:38:44下载
    积分:1
  • Signal_and_Systems_Lab_4
    Signal And System Lab_2
    2012-04-16 14:43:30下载
    积分:1
  • 1-(12)
    Co-Optimization of Generation Unit Commitment and Transmission Switching With N-1 Reliability
    2015-04-03 21:38:19下载
    积分:1
  • FUZZY
    模糊自整定PID控制器设计。 本资料含有详细的PID控制器算法M文件、Simulink模型搭建、模糊控制器设计以及相应的技术文档分析。相信对您一定很有帮助(Fuzzy self-tuning PID controller design. This information contains details of the PID controller algorithm M files, Simulink models to build, fuzzy controller design and analysis of relevant technical documentation. I believe you must be helpful)
    2015-04-10 15:54:49下载
    积分:1
  • MMSimplex
    说明:  单纯形法求解线性规划问题 ,在需要添加人工变量时将采用两阶段法求解上述问题(Simplex method for solving linear programming problems)
    2019-03-28 11:01:09下载
    积分:1
  • 2-Control
    For example, heating up the temperature in a room is a process that has the specific, desired outcome to reach and maintain a defined temperature (e.g. 20°C), kept constant over time. Here, the temperature is the controlled variable. At the same time, it is the input variable since it is measured by a thermometer and used to decide whether to heat or not to heat. The desired temperature (20°C) is the setpoint. The state of the heater (e.g. the setting of the valve allowing hot water to flow through it) is called the manipulated variable since it is subject to control action
    2013-08-16 16:53:45下载
    积分:1
  • 变采样和多相滤波器的实现
    变采样和多相滤波器的实现。本程序实现了一个变采样程序,中间设计滤波器设计和插值抽取。其中滤波器设计用的是窗函数法,根据要求设计窗函数,得到窗函数的长度。接着是插值,滤波,抽取,得到最后变采样之后的波形文件、另外对比了用直接卷积和多相分解卷积两种方法最后的结果。 (Implementation of variable sampling and polyphase filter. This procedure implements a variable sampling procedures, intermediate design and interpolation and decimation filter design. The filter design is using the window function method, according to the requirements of the design of window function, get the length of the window function. Then the interpolation, filtering, extraction, and finally obtain the variable wave file, sampling after the addition of contrast and polyphase decomposition results of two methods for convolution last direct convolution.)
    2021-05-09 18:28:34下载
    积分:1
  • ft_freqanalysis_mvar
    frequency analysis for fRMI
    2013-04-25 21:12:13下载
    积分:1
  • WE
    说明:  稀疏条件下欠定盲分离,得到混合矩阵,恢复原信号(Underdetermined blind separation under sparse conditions)
    2014-01-13 17:10:40下载
    积分:1
  • PFscheduler
    LTE上行中传统用户和点到点用户的比例公平算法(Proportional Fair(PF) scheduling algorithm for both cellular and d2d users in LTE uplink)
    2021-02-28 23:29:35下载
    积分:1
  • 696518资源总数
  • 105547会员总数
  • 4今日下载