登录
首页 » matlab » irisrecognition

irisrecognition

于 2007-05-04 发布 文件大小:2KB
0 148
下载积分: 1 下载次数: 364

代码说明:

   该源代码为一国外硕士所写,有关虹膜特征提取的部分很有借鉴意义,希望从事图象处理方面研究的各位不要错过.(the source code for an overseas master's written, the iris feature extraction part of a useful one, want to engage in image processing research you should not miss.)

文件列表:

iris recognition.txt
read me.txt

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • project
    LARN ABOUT PROJECT DEATAILS
    2014-08-21 15:24:32下载
    积分:1
  • Nested array
    非均匀阵列 + MUSIC 算法的 DOA 例程(DOA routine of non-uniform array + MUSIC algorithm)
    2020-12-15 15:39:15下载
    积分:1
  • greymatlab
    说明:  计算方法参考文献:王宁练:冰川平衡线变化的主导气候因子灰色关联分析 冰川冻土(Calculation References: Wang Ning practice: a balanced line of glaciers to climate change in the dominant factor glacier permafrost gray relational analysis)
    2009-08-18 15:51:00下载
    积分:1
  • myrgb2hsvamyhsv2rgb
    自己实现的rgb2hsv和hsv2rgb函数(the funtions of rgb2hsv and hsv2rgb written by myself)
    2012-04-13 17:07:21下载
    积分:1
  • strech
    去斜率(strech)参考信号与回波信号混频后得到中频输出信号S(t)=Aexp(j*2*pi*f0*t+phase) 其中f0与回波延时的关系为: f0=k*delay_t K为线性调频斜率,delay_t为回波延时 将s(t)采样,FFT变换即可得到目标距离与频谱的关系。 Strech 信号测距 输入混频后的中频信号(图一),经采样及FFT变换得到频谱(图二) 再根据频谱与距离的关系式R=Tcf/2B显示出距离(图三) (Go slope (strech) obtained after the reference signal and the echo signal mixer IF output signal S (t) = Aexp (j* 2* pi* f0* t+phase) f0 and echo delay relationship: f0 = k* delay_t K chirp slope, delay_t the echo delay sampling s (t), the FFT transform to the target distance spectrum of relations. Strech signal ranging input mixer IF signal (Figure 1), sampling and FFT transform spectrum (Figure 2) according the the spectrum distance relationship R = Tcf/2B shows the distance (Figure 3))
    2012-11-27 20:36:34下载
    积分:1
  • Reg_courant_pu
    Controle Per Unit d une MESB
    2012-04-04 02:05:38下载
    积分:1
  • 1
    说明:  电力系统潮流计算程序用MATLAB程序编写的(Newton Raphson power flow calculation program written in MATLAB)
    2010-05-16 14:48:46下载
    积分:1
  • RGB-Histogram-Sideview--improfileadd(I)---File-Ex
    Simple but effective example of "Region Growing" from a single seed point. The region is iteratively grown by comparing all unallocated neighbouring pixels to the region. The difference between a pixel s intensity value and the region s mean, is used as a measure of similarity. The pixel with the smallest difference measured this way is allocated to the region. This process stops when the intensity difference between region mean and new pixel becomes larger than a certain treshold
    2013-09-11 02:38:46下载
    积分:1
  • 5
    说明:  根据滚降系数画出滚降系统频谱,并画出相应的时域波形(According to the roll-off factor to draw the spectral roll-off and draw the corresponding time-domain waveform)
    2014-12-17 17:15:27下载
    积分:1
  • VSC_HVDC
    基于VSC_HVDC的直流配电网研究论文 很详细包括了MATLAB的仿真图(VSC_HVDC-based DC distribution network research papers are detailed in the simulation of MATLAB)
    2017-04-04 20:22:08下载
    积分:1
  • 696518资源总数
  • 106155会员总数
  • 8今日下载