登录
首页 » matlab » A_sinle_phase_semi_RLload

A_sinle_phase_semi_RLload

于 2014-08-09 发布 文件大小:9KB
0 130
下载积分: 1 下载次数: 2

代码说明:

  single phase semi converter with rl load

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论


0 个回复

  • imdqmain
    induction motor dq model in matlab code not simulink
    2014-09-04 04:49:56下载
    积分:1
  • wangluo
    说明:  输入网络参数,从而得到网络的关联矩阵、基本回路矩阵和基本割集矩阵Qf(Enter the network parameters, and thus obtain the network incidence matrix, fundamental circuit matrix and the basic cut-set matrix Qf)
    2010-03-30 18:47:33下载
    积分:1
  • guass_noise
    高斯噪声产生的代码,含有射频噪声干扰的代码(Gaussian noise code, containing RF noise code)
    2021-03-21 19:59:16下载
    积分:1
  • Untitled3
    fp=0.2KHz,Rp=1dB, fs=0.3KHz,As=25dB,T=1ms;用脉冲响应不变法设计一Butterworth数字低通滤波器,观察所设计数字滤波器的幅频特性曲线,记录带宽和衰减量,检查是否满足要求。(fp=0.2KHz,Rp=1dB, fs=0.3KHz,As=25dB,T=1ms;The same method to design a digital low-pass Butterworth filter, observe the design of digital filter frequency characteristic curve, recording the amount of bandwidth and attenuation, check with the impulse response meets the requirements.)
    2015-04-16 10:20:33下载
    积分:1
  • 5.--PSK-Demodulation-(Part-1)
    Phase-shift keying (PSK) is a modulation process whereby the input signal, a binary PCM waveform, shifts the phase of the output waveform to one of a fixed number of states. The demodulation process can be divided into three major subsections, as shown by Figure 4. First, since the incoming waveform is suppressed carrier in nature, coherent detection is required. The methods by which a phase-coherent carrier is derived from the incoming signal are termed, carrier recovery, and will be covered first.
    2014-02-25 16:01:21下载
    积分:1
  • HMMDemo
    implementation of fisherfaces for matlab
    2010-09-17 21:22:21下载
    积分:1
  • csminit
    Fixed 7/17/93 to use inverse-hessian instead of hessian itself in bfgs
    2010-03-04 16:58:33下载
    积分:1
  • Dijkstra
    Dijkstra算法是典型最短路算法,用于计算一个节点到其他所有节点的最短路径。主要特点是以起始点为中心向外层层扩展,直到扩展到终点为止(Dijkstra' s algorithm is a typical shortest path algorithm used to calculate a node to all other nodes of the shortest path. Main features is the starting point for the center layers expand outward until the end date extended to)
    2011-07-20 19:56:45下载
    积分:1
  • dBmtoV
    功率与电压的转换..............(the transfer between power and voltage)
    2011-11-15 19:52:58下载
    积分:1
  • Unitary--ESPRIT-MATLAB
    Unitary -ESPRIT-MATLAB程序,用于近场声全息的定位,阵列信号的处理。(good,very good.)
    2013-05-15 16:23:35下载
    积分:1
  • 696518资源总数
  • 104863会员总数
  • 25今日下载