登录
首页 » matlab » calibr

calibr

于 2007-11-01 发布 文件大小:32KB
0 148
下载积分: 1 下载次数: 13

代码说明:

  The camera calibration toolbox for Matlab (version 3.0) utilizes a new bias correction procedure for circular control points and a nonrecursive method for reversing the distortion model

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • matlab-PCA
    本程序提供主成分分析算法,该算法有四个小程序组成,简单,实用。(This program provides the main element analysis of the algorithm, the algorithms are four small and simple, practical. )
    2010-07-17 15:28:05下载
    积分:1
  • Matlab-symdisp
    在Matlab中显示公式,比Matlab自带的函数效果好(In Matlab show that formula, than with Matlab function effect is good )
    2014-09-18 08:55:43下载
    积分:1
  • genetic-algorithm
    本人收集的关于遗传算法方面的matlab程序,量很大,一定有您想要的东西(genetic algorithm collenction)
    2014-12-23 15:45:29下载
    积分:1
  • SVM-toolbox
    说明:  迄今为止最好的svm工具箱 包含了波形和图像的处理(svm classification)
    2010-04-23 16:08:08下载
    积分:1
  • solar_mppt_boost
    太阳能电池MPPT研究用simulink仿真模型,使用2010b版本编辑的 之前的老版本应该打不开 包括PV模型,boost电路 mppt电路等整个完成电路,可以直接出波形的(Solar cell MPPT research using simulink simulation model, the use of 2010 b version before the old version of the editor should be can t open include PV model, the boost circuit MPPT circuit of the complete circuit, can be directly out of the waveform)
    2020-06-30 13:40:02下载
    积分:1
  • 1
    说明:  边射直线阵天线波束方向图演示程序 直线阵最常见的工作模式(Broadside linear array antenna beam pattern demo linear array of the most common mode of)
    2010-10-26 14:48:06下载
    积分:1
  • 基于SVM电力系统短期负荷预测的一个
    说明:  短期电力负荷预测,支持向量机结合粒子群算法进行短期电力负荷预测的实例(short-time load forecasting)
    2020-10-20 22:37:25下载
    积分:1
  • MFuzzyMF-master
    说明:  cluster selection based on fuzzy rules
    2020-05-18 14:19:03下载
    积分:1
  • circle1
    利用有限差分算法实现动力学方程的求解单个球体在环形容器中运动分析(Finite difference algorithm for solving the dynamic equations in a single sphere in the circular movement of the container)
    2010-11-22 16:27:32下载
    积分:1
  • RGLS
    该算法用于自回归输入模型,是一种迭代的算法。其基本思想是基于对数据先进行一次滤波处理,后利用普通最小二乘法对滤波后的数据进行辨识,进而获得无偏一致估计。但是当过程的输出信噪比比较大或模型参数较多时,这种数据白色化处理的可靠性就会下降,辨识结果往往会是有偏估计。数据要充分多,否则辨识精度下降。模型阶次不宜过高。初始值对辨识结果有较大影响。(The algorithm used for autoregressive input model, it is a kind of iterative algorithm. The basic idea is based on data to conduct a filtering processing, after using ordinary least square method to identify the data filter, and then obtain unbiased consensus estimates. But when the process output signal-to-noise ratio is larger or model parameters are too, this kind of data white processs reliability will drop, identification results tend to be biased estimate. Data should fully, otherwise the identification accuracy down. Model order time shoulds not be too high. Initial value to identification results have great influence on.)
    2012-12-28 16:04:47下载
    积分:1
  • 696518资源总数
  • 105873会员总数
  • 12今日下载