-
1
说明： 從三角求和公式到Fourier 級數,推导很详细(From the Triangle to the Fourier series summation formula, derived in great detail)
- 2010-04-04 11:34:25下载
- 积分：1
-
Imageequilibria
说明： 这是我自己写的一个Matlab原代码：直方图均衡化，另外送上别人写的一种算法，给大家比较，接下来我还想写一种能强化细节的自适应直方图均衡法。。请大家多多指教(that I wrote an original Matlab code : histogram equalization, and send the others to write an algorithm for the sake of comparison, the next one I want to write details can be enhanced adaptive histogram equalization method. . Please exhibitions. .)
- 2006-04-10 21:19:16下载
- 积分：1
-
Rician
设计了信息在空间传输的莱斯信号模型,当接收端存在一个主要的静态信号时，如LOS分量（如在郊区和农村等开阔区域中）等，此时接收端接收的信号的包络就服从Rician分布。(Rician signal model)
- 2014-08-11 10:28:17下载
- 积分：1
-
cmopso
典型的多目标粒子群算法（CMOPSO)，附测试函数,注解详细，适合学习参考(A typical multi-objective particle swarm optimization (CMOPSO), attached to the test function, annotation detailed reference for learning)
- 2013-11-30 10:40:24下载
- 积分：1
-
psd_est
Power Spectrum Estimation
- 2009-10-05 18:08:55下载
- 积分：1
-
FCM_clust
本文在阐述聚类分析方法的基础上重点研究FCM聚类算法。FCM算法是一种基于划分的聚类算法，它的思想是使得被划分到同一簇的对象之间相似度最大，而不同簇之间的相似度最小。最后基于MATLAB实现了对图像信息的聚类。( This paper describes the basis of cluster analysis methods and focus on the FCM clustering algorithm. FCM algorithm is a clustering algorithm based on division and the idea is to make it to the same cluster is divided into the biggest similarity between the objects, while the minimum similarity between different clusters. Finally, I realize the implementation of image information of the cluster based on MATLAB.)
- 2013-01-05 21:05:53下载
- 积分：1
-
项目4
说明： 任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。
要求：
1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。
2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。
3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify.
Requirement:
1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km.
2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm.
3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)
- 2019-05-13 09:39:41下载
- 积分：1
-
MPC_state
MPC using steady state model
- 2021-02-09 13:49:53下载
- 积分：1
-
hungcode
matlab code for hungarian code in matrix format solves channel assignment problems
- 2011-12-01 12:36:42下载
- 积分：1
-
adaboost9.26
adaboost方法实现人脸分类 可直接运行的程序(face classification method implementation adaboost)
- 2010-09-26 15:37:01下载
- 积分：1
