-
qqbiaoqing
基于matlab编写的QQ表情程序，内有说明(QQ expression program based on Matlab prepared)
- 2012-05-28 13:31:14下载
- 积分：1
-
Digital-Filter-Design
(1)设计低通、带通、高通数字滤波器；
(2)可以对合成信号(含低频、中频、高频分量)、语音信号进行滤波；
(3)通过GUI界面进行控制。((1) design low pass, band pass, high pass digital filter
(2) can be synthesized signal (including the low frequency, medium frequency, high frequency components), filtered speech signal
(3) is controlled through the GUI.)
- 2020-10-28 10:49:59下载
- 积分：1
-
dlb_lqr11
一级倒立摆系统采用最优控制的方法，改变状态增益系数K，最后使系统达到平衡。(Inverted pendulum system using optimal control methods to alter the state of the gain coefficient K, the last to make the system balanced.)
- 2010-09-30 21:32:21下载
- 积分：1
-
MatlabFiles
This folder or any similar folder such as this created to hold your speech files, should be copied into the root folder C: , created on the local hard drive. Then the path will read thus C:SpeechDataTope... etc. An alternative is to modify the file setTemplates.m to change the directory as appropriate.
Try to use the same microphone for training as well as for recognition to obtain improved accuracy. You might also need to tweak your sound card s mic input level.
The recognition time is dependent on systems s processing power and has been observed at between 1 and 5 seconds on various x86 platforms. To speed up recognition, you can implement unconstrained DTW (this is the code portion taking most time).
- 2010-11-26 15:30:54下载
- 积分：1
-
di9zhang
基于MATLAB图像处理技术随书源代码第9章(MATLAB-based image processing technology with the book source code Chapter 9)
- 2013-11-28 09:36:59下载
- 积分：1
-
潮流计算程序1
说明： 潮流计算是电力学名词，指在给定电力系统网络拓扑、元件参数和发电、负荷参量条件下，计算有功功率、无功功率及电压在电力网中的分布。潮流计算是根据给定的电网结构、参数和发电机、负荷等元件的运行条件，确定电力系统各部分稳态运行状态参数的计算。通常给定的运行条件有系统中各电源和负荷点的功率、枢纽点电压、平衡点的电压和相位角。待求的运行状态参量包括电网各母线节点的电压幅值和相角，以及各支路的功率分布、网络的功率损耗等。(Power flow calculation is a term of power science. It refers to the calculation of the distribution of active power, reactive power and voltage in power network under given network topology, component parameters and generation and load parameters. Power flow calculation is based on the given grid structure, parameters and operation conditions of generator, load and other components to determine the steady-state operation parameters of each part of the power system. Usually, the given operating conditions include the power of each power source and load point, junction voltage, balance point voltage and phase angle. The parameters to be determined include the voltage amplitude and phase angle of each bus node, the power distribution of each branch and the power loss of the network.)
- 2020-06-23 10:00:01下载
- 积分：1
-
FDTD-UPML
有限时域差分源程序，边界条件为各向异性完全匹配层（Upml）(FDTD source, boundary conditions for the anisotropic perfectly matched layer (Upml))
- 2020-06-30 03:20:01下载
- 积分：1
-
frft
利用分数阶傅里叶变化进行高分辨率的时频分析的文章，非常不错。(Changes in fractional Fourier using high-resolution time-frequency analysis of articles, very good.)
- 2009-11-24 17:13:39下载
- 积分：1
-
16QM_viterbi_hard
通信中的tcm&16qam体制的研究，matlab源程序代码，采用viterbi应判决译码(Communication tcm & 16qam study of the structure, matlab source code, used to be decision viterbi decoding)
- 2010-03-04 17:05:55下载
- 积分：1
-
MATLAB6.5-and-Simulink
matlab6.5参考手册，是英文版的。里面含有simulink的参考手册。(matlab6.5 Reference Manual is in English. Simulink which contains a reference manual.)
- 2010-10-28 22:38:43下载
- 积分：1
