-
ICAforImage
一个对几幅图象进行盲信号分离的MATLAB程序。
分离性能还不错。(The pieces of an image for Blind Signal Separation of the MATLAB program. Separation performance is not bad.)
- 2010-02-22 18:16:19下载
- 积分：1
-
DCTyinxie
图像的DCT变换域的隐写matlab程序代码(DCT transform domain image steganography matlab code)
- 2014-02-19 21:08:53下载
- 积分：1
-
relnwt021203
该代码为盲源分离中的相对牛顿法，收敛性能稳定，分离效果优越，值得借鉴。(The code for the blind source separation of the relative Newton method, convergence properties of stability and separation efficiency is superior, is worth learning from.)
- 2007-12-02 21:07:39下载
- 积分：1
-
ofdmsim
在训练序列方法中，介绍了时域结构不同的三种算法，比较了它
们的估计性能。在循环前缀算法这一节中，提出了一种基于循环前缀的改进算法，(No Ordinary Blanket
This is my blanket.
My blanket is not just an ordinary blanket.
My blanket can change into different things.
If I tie it around my neck,
my blanket can change into a cape.
“I am Superman!”
If I drape it between two chairs,
my blanket can change into a fort.
“I am the captain of my fort!”
If I put it over my head,
my blanket can change into a ghost)
- 2011-05-23 16:20:39下载
- 积分：1
-
jianchuanzaoshengxinhao
一个舰船噪声信号仿真建模的程序，已经测试通过，并且可以实际应用，修改参数即可仿真各类特殊的信号(A ship noise signal simulation and modeling procedures have been tested, and practical application, modify the parameters to simulation of various types of special signal)
- 2012-06-27 14:29:45下载
- 积分：1
-
AG
说明： Algorith Genetics of book Inteligencia artificial con aplicaciones a la ingeniería, pedro ponce cruz.
- 2014-10-07 11:44:33下载
- 积分：1
-
compoversamp
说明： 此程序是抽样和计算自相关子程序，可以为我们提供参考(This procedure is sampling and calculation of autocorrelation subroutine, you can provide us with a reference)
- 2008-10-16 20:33:52下载
- 积分：1
-
适应度函数的算法
排课问题是一个有约束的、多目标的组合优化问题，并且已经被证明是一个NP完全问题。
遗传算法借鉴生物界自然选择和自然遗传机制，使用群体搜索技术，尤其是用于处理传统搜索方法难以解决的复杂的和非线性的问题。经过近40年的发展，遗传算法在理论研究和实际应用中取得了巨大的成功，本文将遗传算法用于排课问题的求解，首先讨论了排课问题中的影响因素、主要约束条件、求解目标和难点，并用数学模型完整地描述了排课问题。其次对多个模糊排课目标进行了定量分析，建立了排课优化目标空间。针对排课问题研究了染色体编码方式以及遗传算子的设计，提出了适应度函数的计算方法。最后对排课问题进行了实验。实验结果表明，其过程的目标值跟踪显示，算法稳健趋优，所得结果令人满意。(Course Scheduling problem is a constrained, multi-objective optimization problem, and has proven to be a NP complete problem.
Genetic algorithms reference biosphere and the natural genetic mechanism of natural selection, using the group search technology, particularly the traditional search methods for handling complex and difficult to solve nonlinear problems. After nearly 40 years of development, the genetic algorithm in the theoretical study and practical application was a great success, this paper genetic algorithm for solving the course timetabling problem, first discussed the impact of factors in the course arrangement, the main constraints, to solve goals and difficulties, and a complete mathematical model to describe the course arrangement. Arranging multiple fuzzy goals followed by a quantitative analysis, the optimal target Arranging space. Arranging for the Study of the chromosome coding and genetic operators design, proposed fitness function is calculated. Finally, the co)
- 2010-05-13 11:49:12下载
- 积分：1
-
chengxu
小波变换进行变速箱故障诊断
首先将s1和s2信号时域谱（s1代表维修前的振动信号，s2代表维修后的振动信号），画出来进行对比，会发现s1信号的振动幅值会比较高；然后对s1和s2分别进行小波分解并画出各层的时域谱，只对比s1和s2分后的最高时域谱，s2更加的具有周期性，且幅值较小，s2周期性不够明显，且振动过于密集。分析完时域谱后开始分析频谱，首先对原信号s1和s2fft转换，得到频谱图，如图，然后再对小波分析后高频部分进行fft转换，做出频谱图。对比后我们发现，在f 2375HZ出（也就是齿轮的啮合频率），s1信号频谱幅值会有急剧的升高，然后，其谐波的幅值也会增大。所以可以推断出该维修前的增速箱的齿轮可能出现问题。(Gearbox fault diagnosis based on wavelet transform s1 and s2 first time domain signal spectrum (s1 behalf of the vibration signal before maintenance, vibration signal s2 representative of repaired), drawn comparison, you will find a signal s1 vibration amplitude will be higher then s1 and s2 respectively wavelet decomposition and draw the layers of time-domain spectrum to only a maximum time domain spectroscopy s1 and s2 points after, s2 is more cyclical and smaller magnitude, s2 cyclical enough obviously, and the vibration is too dense. End domain spectral analysis after the beginning of the spectrum analysis, the first of the original signal s1 and s2fft conversion to give the spectrum, as shown, and then after the high frequency part of wavelet analysis fft transformation to make spectrum. We found that after the comparison, at f 2375HZ out (i.e. the gear mesh frequency), there will be a sharp increase in the amplitude spectrum of the signal s1, and then, the amplitude of the ha)
- 2017-01-17 19:18:02下载
- 积分：1
-
matlab
this ile has been written to my friends in pudn and i believe it is useful for u.
tjhanks for ur attention
- 2009-09-10 21:47:22下载
- 积分：1
