-
ball
基于matlab的球杆模型simulink(Simulink model based on the club matlab)
- 2009-12-04 10:57:29下载
- 积分：1
-
Wiener
设计一维纳滤波器。产生三组观测数据，并估计它们的AR模型参数，分析信号长度和模型阶次对实验结果的影响(Wiener filter design. Have three sets of observational data, and estimated AR model parameters of their analysis of the signal length and model order on the impact of experimental results)
- 2009-06-14 15:55:45下载
- 积分：1
-
match_ransac
利用matlab，ransac算法直线拟合(Use matlab, ransac linear fitting algorithm)
- 2014-11-22 21:44:19下载
- 积分：1
-
Codice
经典MATLAB算法，插值计算，拟合，绘图等(Classic MATLAB algorithms, interpolation, fitting, drawings, etc.)
- 2013-12-07 21:45:36下载
- 积分：1
-
paper1
A Mean-field Approach for an Intercarrier Interference Canceller for OFDM
- 2015-03-12 22:21:42下载
- 积分：1
-
command_in_out
可以用该程序来学习simulink,是最基础的东西(you can use it to study simulink)
- 2009-04-26 10:16:47下载
- 积分：1
-
eee
杨氏双缝干涉
两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2,
满足相干条件的光波叠加后，对于观察屏上某一确定点，即r1、r2确定后，叠加后的光强为 式中λ为光波的波长， 、 ，令相位差φ=2π（r2-r1）/λ,
最后可得公式如下：
，
最后光强I=4I0cos2（Φ/2）。
观察相干光叠加后光强的分布.
(Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)
- 2013-01-03 21:04:13下载
- 积分：1
-
ningqiqi_steady
凝汽器稳定工况下，换热平衡下的相关计算。(Condenser stable condition, the relevant calculations of the heat balance)
- 2011-10-21 20:06:58下载
- 积分：1
-
fdtd2D
finite difference time domain 2d code
- 2010-10-30 07:20:18下载
- 积分：1
-
Matlab
说明： 学习matlab的简单 30程序 如追赶法求解三对角方程(Chase method Tridiagonal)
- 2011-04-15 09:06:01下载
- 积分：1
