-
RLS
仿真对象如下：
其中， v( k )为服从N (0,1) 分布的白噪声。输入信号u ( k) 采用M 序列，幅度为 1。M 序列由 9 级移位寄存器产生，x(i)=x(i-4)⊕x(i-9)。
选择如下辨识模型：
加权阵取Λ = I。
衰减因子β = 0.98，数据长度 L = 402。
辨识结果与理论值比较，基本相同。辨识结果可信
(he simulation object is as follows: among them, v (k) to obey N (0, 1) distribution of white noise. The input signal u (k) using M sequence, amplitude is 1. M sequence by 9 level shift register generation, x (I) = x (I- 4) ⊕ x (I- 9). Choose the identification model: weighted array take Λ = I. Attenuation factor β = 0.98, the data length L = 402. Identify the theoretical calculation and comparison, basically the same. Identification results are reliable)
- 2012-12-28 15:49:33下载
- 积分：1
-
IterSVD_MIMO_Cap
MIMO 场景下的SVD分解后，进行eigenvector预编码所获得信道容量(the capacity after deploying eigenvector beamforming)
- 2012-04-27 10:20:19下载
- 积分：1
-
EKF_UKF_PF
EKF_UKF_PF三种算法的比较，仿真结果很明显。(EKF_UKF_PF comparison of three algorithms, simulation results are obvious.)
- 2013-08-10 16:24:08下载
- 积分：1
-
RBF-network-sliding
基于RBF网络补偿的控制输入受限滑模控制(Compensation control based on RBF network sliding mode control input constraints)
- 2013-11-11 13:42:58下载
- 积分：1
-
alamouti-vs-no-diversity-vs-mrc
alamouti方案的误比特率仿真
包含无分集，发射分集(2Tx, 1Rx)，发射分集(2Tx, 2Rx)，MRC接收分集 (1Tx, 2Rx)的误比特率曲线
在matlab r2010b 中已运行通过。(alamouti program the mistakenly bit rate simulation contains no diversity transmitter sub-sets (2Tx, 1Rx) emission sub-set (2Tx, 2Rx) MRC receiving sub-set (1Tx, 2Rx) the incorrect bit rate curve matlab r2010b has run through.)
- 2012-11-04 10:51:52下载
- 积分：1
-
MPSK_Simulation(BPSK_QPSK_8PSK)
说明： MPSK之2，4，8取值时的幅度相位键控仿真程序(MPSK values 2,4,8 of magnitude when the phase shift keying simulation program)
- 2008-09-27 11:53:05下载
- 积分：1
-
fading_simulink
Channel fading using Matlab simulink
- 2014-11-09 01:42:13下载
- 积分：1
-
ipeak5
The additional argument (PeakD) is roughly the ratio of the typical
peak width to the length of the entire data record. Small values
detect fewer peaks larger values detect more peaks. It effects only the
starting values for the peak detection parameters. (This is just a quick
way to set reasonable initial values of the peak detection parameters,
rather than specifying each one individually as in example 5.
- 2013-05-07 17:01:07下载
- 积分：1
-
matlabask5
Automatic Control Systems
- 2015-03-26 20:39:23下载
- 积分：1
-
matlab-11
单纯形法的灵敏度分析 有需要的人可以看看 (matlab )
- 2015-11-28 23:25:25下载
- 积分：1
