-
matimage
THE FEATURE IS BILINEAR-INTERPOLATE THE SOUCE-IMAGE TO GET A DESTINATE-IMAGE
- 2008-01-14 23:39:06下载
- 积分：1
-
AforME
Block Matching Algorithms For Motion Estimation
- 2012-04-09 20:42:51下载
- 积分：1
-
pufenxi
对信号进行谱分析，并根据谱分析结果绘制谱分析结果图。(The signal spectrum analysis, and mapping of the spectral analysis of the results of spectral analysis graph.)
- 2011-05-15 19:59:47下载
- 积分：1
-
suspension
二自由度的四分之一车辆悬架模拟，非主动悬架 simulink模型
(A quarter of the two degrees of freedom vehicle suspension simulation, the active suspension model of simulink
)
- 2014-06-06 20:43:19下载
- 积分：1
-
用Z-N法实现P，PI，PID控制的参数整定
用MATLAB程序软件完成Z-N法对控制器的参数整定，实现P,PI,PID控制器的分别参数整定，并求出控制器的控制参数Kp，Ti，Td。最后绘制出不同控制器控制下的及参数整定前后的单位阶跃响应图进行比较。(MATLAB program software is used to complete the parameter tuning of the controller by Z-N method. The parameters of P, PI, PID controller are adjusted, and the control parameters of the controller Kp, Ti, Td are obtained. Finally, the unit step response diagram before and after parameter tuning is plotted under different controller control.)
- 2021-03-18 10:49:20下载
- 积分：1
-
music的各种算法
music算法，可用于雷达超分辨成像，提高图像分辨率(music algrithem,It can be used in radar super-resolution imaging to improve image resolution)
- 2020-11-01 20:59:55下载
- 积分：1
-
truss_f
A code to solve a 2-D truss structure using FEM theorem (direct method). Each branch of the truss is considered as a 2-force member and the coordinates of the nodes in Cartesian system is needed. This code contains 3 functions:
Truss_f, which is the main function to calculate stress, strain and force.M_properties22, which contains the mechanical properties of whole truss in a matrix
P_condition22, which contains boundary condition and external forces in a matrix
- 2012-08-02 16:29:31下载
- 积分：1
-
untitled11
永磁直线电机的simulink的仿真模型，可以得到运行状况(Permanent magnet linear motor simulink simulation model can be run situation)
- 2020-11-26 18:49:31下载
- 积分：1
-
DCMOTOR
matlab code for dc motor design 2
- 2012-09-15 17:32:12下载
- 积分：1
-
yichuansuanfa3
遗传算法matlab程序，步骤为设置最大迭代步数、计算当前最大的适应度、设置初始取值范围[0 255]、进入加速迭代的间隔、选择交叉、变异等(Genetic algorithm matlab program, the steps to set the maximum number of iterative steps to calculate the current maximum of fitness, set the initial range [0 255], into the accelerated iteration interval, choose the crossover and mutation)
- 2011-09-21 17:29:09下载
- 积分：1
|
联系客服（QQ：3324461878）
