登录
首页 » Visual C++ » 13-5-1

13-5-1

于 2013-11-17 发布 文件大小:2KB
0 182
下载积分: 1 下载次数: 1

代码说明:

  电子时钟的小程序,基于89c51单片机,可以实现定时、计时、修改时间等功能。(Electronic clock applet, based on 89c51 microcontroller, can achieve timing, timing, modification time and other functions.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • ADC1_TriggerConversion
    根据对应的按键值,对应输出相应的电容值,并做掉电检测(According to the corresponding key value, corresponding to the output of the corresponding capacitance values ​ ​ and do brownout detection)
    2013-11-26 23:42:16下载
    积分:1
  • calculator
    这是基于单片机的计算器程序,可以实现加减乘除的功能(This is based on single-chip calculator program, Math functions can be achieved)
    2011-11-11 13:32:40下载
    积分:1
  • ct46
    说明:  计算不同的三分CANTOR集,可以由此验证WTMM的正确性(CANTOR different set of one-third can thus verify the correctness of WTMM)
    2009-08-09 10:25:35下载
    积分:1
  • 905--
    nrf905 接收机程序 89C52 验证通过 绝对好使(nrf905 receiver program 89C52 verified through absolutely so)
    2013-08-13 11:29:01下载
    积分:1
  • GEADVANCE3D_Sinogram
    数据转换为正弦图,最终输出的正弦图为平均正弦图。(Data into sine figure, final output sine the graph is the average sinogram.)
    2013-10-07 15:26:07下载
    积分:1
  • powerdemo_6.5.1
    伺服电机控制系统,02年开始积累,效果好,速度快,PI控制,经典控制,fuzzy PID,自适应控制,速度位置控制等等,欢迎大家参考。(Servo motor control system, in 2002 began to accumulate, effective, fast, PI control, classical control, fuzzy PID, adaptive control, speed position control, etc., we welcome the reference.)
    2013-12-11 14:16:50下载
    积分:1
  • 200684154022
    正弦信号发生器[2005年电子大赛一等奖].files(sinusoidal signal generator [e-Competition in 2005 won first prize]. Files)
    2006-09-07 21:49:27下载
    积分:1
  • jbrj
    针对RN8209新型电表计量芯片的校表软件,使用DLT645-2007通讯协议(RN8209 for new electricity metering chip calibration software, communications protocols using DLT645-2007)
    2021-02-01 14:40:00下载
    积分:1
  • Tabrizi
    AVR files example that drive Interrupt and LCD and others
    2015-08-18 20:00:05下载
    积分:1
  • 110kv
    根据设计任务书的要求,本次设计为110kV 变电站电气一次部分初步设计,并绘 制电气主接线图及其他图纸。该变电站设有两台主变压器,站内主接线分为110kV、 35kV 和10kV 三个电压等级。各个电压等级分别采用单母线分段接线、单母线分段带 旁母接线和单母线分段接线(From the guide of engineering design assignment, we have to design primary power-system of 110kV substation and draw main electrical one-line diagram and others. There are two main transformer in the substation in which main electrical connection can be divided into three voltage grades: 110kV, 35kV with 10kV.It deposits sectionalized single bus bar scheme, sectionalized single and transfer bus bar and sectionalized single bus bar scheme per grade.)
    2020-11-01 11:49:54下载
    积分:1
  • 696518资源总数
  • 106161会员总数
  • 5今日下载