-
51
说明： 51单片机串口控制继电器的C源程序，用电脑控制继电器(51 MCU C source control relay)
- 2014-02-21 22:34:42下载
- 积分：1
-
SDT-V1.0
用CMS16P52写的手电筒：
带摁键的，有注释(A flashlight with CMS16P52 written: with key pressed, Notes)
- 2013-03-15 13:29:54下载
- 积分：1
-
stm32-pos-drives
STM32 POS机底层驱动程序，包含打印机驱动程序，SPI FLASH驱动程序，RC522驱动程序 ，PASM卡（7816）驱动程序，磁条卡驱动程序，ILI932X液晶模块驱动程序，键盘驱动程序等(STM32 POS bottom driver, including printer driver, SPI FLASH driver, RC522 driver, PASM card (7816) driver, magnetic stripe card driver, ILI932X LCD module driver, keyboard driver, etc.)
- 2019-04-20 11:45:35下载
- 积分：1
-
modbus-TCPIP
modbus TCPIP协议client-Server代码,c++。(TCPIP client-Server protocol MODBUS source code and analysis, c++ programming.
)
- 2016-09-24 20:54:49下载
- 积分：1
-
DS1302P18B20P1602
该程序实现了用单片机来控制时钟芯片DS1302进行万年历的显示。
这个代码相对来说很复杂，注释比较多。
程序运行，首先设置时间。
按S19，进行某一位的设置，会看到某一位上面会闪烁。
按S20，数值加1.
按S21，数值减1.
设置完后，时间会进行运行。
另外,1602上也会有时间显示的。(The program implements the MCU to control the clock chip DS1302 conducted calendar display.
This code is relatively complex, comment more, we can carefully analyzed.
The program runs, the first set the time.
By S19, conducted a one set, you will see a bit above flashes.
By S20, the value plus 1.
By S21, the value minus 1.
After setting, the time will be run.
Further, the time will be displayed in 1602.)
- 2013-12-13 13:48:55下载
- 积分：1
-
瑞萨串口显示LCD12864
说明： 瑞萨单片机显示程序。利用串口实现数据通讯收发液晶屏显示(Risa MCU display program. Using Serial Port to Realize Data Communication Transceiver LCD Display)
- 2020-06-24 09:40:07下载
- 积分：1
-
5933
AD5933评估板下位机程序（keil C）和上位机程序（VB）(AD5933 Evaluation procedures under the plan (keil C) and PC (VB))
- 2021-01-28 00:48:35下载
- 积分：1
-
practice1
工程教育中级练习题1：按一下K1键，LED以10Hz频率闪烁，屏幕上画出红圈，跟着闪，放开后保持该频率闪烁；长按K1键超过3秒，LED以5Hz频率闪烁，屏幕上画出红圈，跟着闪，放开后保持该频率闪烁；按一下K2键，LED熄灭；按一下K2键，LED常亮。(Secondary Exercise Question 1 in Engineering Education: Press the K1 key, the LED flickers at 10Hz frequency, draw a red circle on the screen, follow the flash, and keep the frequency flickering after release; Press the K1 key for more than 3 seconds, the LED flickers at 5Hz frequency, draw a red circle on the screen, follow the flash, and keep the frequency flickering after release; Press the K2 key, the LED goes out; Press the K2 key, the LED always shines.)
- 2019-05-15 23:01:13下载
- 积分：1
-
MP3播放器实验
说明： 实验器材:
MiniSTM32F103开发板V3版本
实验目的:
学习VS1053的使用,实现一个简单的MP3.
硬件资源:
1,DS0(连接在PA8)
2,串口1(波特率:9600,PA9/PA10连接在板载USB转串口芯片CH340上面)
3,ALIENTEK 2.8/3.5/4.3/7寸TFTLCD模块(通过GPIO驱动,连接关系见lcd.h)
4,W25Q64(SPI FLASH芯片,连接在SPI1上)
5,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP)
5,SD卡,通过SPI1连接
6,ATK-VS1053模块与STM32芯片连接关系为(请按如下接线连接Mini板和MP3模块):
ATK-VS1053模块----------STM32芯片
VS_SCK ----------- PA5
VS_MISO ------------ PA6
VS_MOSI ------------ PA7
VS_RST ------------ PA11
VS_XDCS ----------- PA4
VS_XCS ----------- PA8
VS_DREQ ------------ PA12
5V ------------ 5V
GND ------------ GND(Laboratory equipment:
MiniSTM32F103 Development Board V3 Version
The purpose of the experiment is:
Learn the use of VS1053 and implement a simple MP3.
Hardware resources:
1, DS0 (connected to PA8)
2. Serial port 1 (baud rate: 9600, PA9/PA10 connected on board USB to serial chip CH340)
3, ALIENTEK 2.8/3.5/4.3/7 inch TFTLCD module (driven by GPIO, connection relationship see lcd.h)
4, W25Q64 (SPI FLASH chip, connected to SPI 1)
5. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP)
5, SD card, connected by SPI1
6. The connection relationship between ATK-VS1053 module and STM32 chip is as follows (please connect Mini board and MP3 module according to the following wiring):
ATK-VS1053 Module - ----- STM32 Chip
VS_SCK------------- PA5
VS_MISO---------------- PA6
VS_MOSI---------------- PA7
VS_RST---------------- PA11
VS_XDCS------------- PA4
VS_XCS--------------- PA8
VS_DREQ---------------- PA12
5V--------------- 5V
GND--GND)
- 2020-06-22 05:00:02下载
- 积分：1
-
NonlinearPSystems(3rdPEdition)
控制系统，自动化专业经典教材《非线性系统》英文第三版(Control systems, automation classic textbook " nonlinear systems" English Third Edition)
- 2013-08-31 11:41:58下载
- 积分：1
