登录
首页 » matlab » jidaishuzitongxinxitong

jidaishuzitongxinxitong

于 2013-06-22 发布 文件大小:5KB
0 105
下载积分: 1 下载次数: 9

代码说明:

  用 MATLAB 对基带数字通信系统进行仿真。整 个系统模拟了发送和接收的全过程。其中调制部分采用 16QAM,并且采用基带传输(Using MATLAB for baseband digital communication system simulation. The system simulates the entire process of sending and receiving. Where the modulation part is 16QAM, and using the base band transmission)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • CCSDS_LDPC
    说明:  CCSDS推荐的LDPC编码方案,一系列参考标准,很好哦!(CCSDS recommended LDPC coding scheme, a series of reference standards, very good!)
    2020-06-15 23:00:02下载
    积分:1
  • LDPC.DIFFERENT-DIEDAICISHU
    LDPC码不同迭代次数对比。码长512,码率1/2,迭代次数分别为0,5,10,50,100.(The LDPC codes different number of iterations contrast. Long code 512, code rate 1/2, the number of iterations were 0,5,10,50,100.)
    2012-11-22 10:57:19下载
    积分:1
  • cdma_mmse
    cdma系统,发射机采用直接扩频序列后发射,接收机采用MMSE接收机(cdma systems, the transmitter after the launch of direct sequence spread spectrum receiver using MMSE Receiver)
    2009-11-06 00:03:34下载
    积分:1
  • 非规则LDPC码在AWGN信道下的性能仿真
    非规则LDPC码在AWGN信道下的性能仿真,码长1024,码率0.5,调制方式QPSK(simulation of LDPC codes in AWGN channel)
    2020-06-28 18:20:01下载
    积分:1
  • Array_erjiezhui
    说明:  本程序为一宽带波束形成程序,基于二阶锥规划求解。可以直接运行,但使用者必须提前下载并安装CVX凸优化工具包。(This program is a broadband beamforming program based on second-order cone programming. It can run directly, but users must download and install the CVX convex optimization toolkit in advance.)
    2019-09-22 18:54:09下载
    积分:1
  • AUCFR-thesistemplate
    thesis document used for ph.d degree
    2019-03-24 22:22:49下载
    积分:1
  • VBLASTMMSE
    说明:  仿真V-BLAST结构MMSE检测算法性能,调制方式为QPSK(The performance of V-BLAST MMSE detection algorithm is simulated, and the modulation mode is QPSK)
    2021-01-15 11:04:14下载
    积分:1
  • 05441004
    Multiple input multiple output techniques combined with orthogonal frequency division multiplexing (MIMO-OFDM) provide a promising approach for wireless systems. However, a serious drawback of the OFDM system is the high peak-toaverage power ratio (PAPR), which may severely affect the power efficiency of RF power amplifiers. In this paper, we propose a simple method to reduce the PAPR of MIMO-OFDM signals based on the use of unused subcarriers. Instead of processing the signals at each transmitter separately, a peak cancelling signal is generated at one antenna and is then applied to all the others with only simple modifications. Simulation has shown that a minimum 2 dB reduction in PAPR can be achieved for all transmit signals using this approach. As the signal processing is nearly all done at a single transmitter, repetition of the operations at each transmitter is avoided, and therefore the overall cost of the system can be significantly reduced.
    2011-11-05 01:46:42下载
    积分:1
  • protobuf-build
    一种轻便高效的数据格式,平台无关、语言无关、可扩展,可用于通讯协议和数据存储等领域。完整的编译工程。(A portable and efficient data format, platform-independent, language-independent, scalable, can be used in communication protocols and data storage and other fields. Complete compilation engineering.)
    2020-06-17 21:00:07下载
    积分:1
  • 软件信体系结构规范 SCA 4.1
    软件无线电体系结构规范。软件无线电开发设计者必备的资料!(Specification for SW arch in SDR)
    2017-11-06 17:39:47下载
    积分:1
  • 696524资源总数
  • 103855会员总数
  • 91今日下载