登录
首页 » matlab » fault

fault

于 2020-08-13 发布
0 180
下载积分: 1 下载次数: 4

代码说明:

说明:  双三相永磁同步电机simulink仿真,包括SPWM模型等(Double three phase permanent magnet synchronous motor)

文件列表:

fault.slx, 49333 , 2020-07-01

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • lfmsk_code
    这是matlab的代码,用于lfmsk雷达波形和比相法测角的仿真代码,望有用的人自取(this is used to simulate the lfmsk and angle figuring)
    2021-04-20 19:28:50下载
    积分:1
  • mpc
    解决了QP问题的一种方法,参考书 Model Predictive Control System Design and Implementation Using MATLAB(solve QP problem. Refer to Model Predictive Control System Design and Implementation Using MATLAB)
    2020-12-09 21:49:19下载
    积分:1
  • 三极管放大电路设计
    说明:  三极管放大实验电路,包括固定偏置/分压偏置,需要根据一些参数确定所选用的电阻值,使得三极管工作在放大状态。本程序将电路设计设计成GUI模式,界面上只需要输入电路设计所需参数,根据相关理论推导,给出相关参数的理论值(放大倍数、输入电阻、输出电阻等),指导实验电路搭建。软件搭建在matlab gui上,方便使用 若干参数说明 beta:三极管放大倍数 Ic:集电极电流 Uce:期望CE间电压 UeCof:Re电阻上点电压与Ucc电压比值,一般0.1-0.2 IbCof:Ib上电流与流过Rb1、Rb2电流的比值,一般0.1 ShuntCe:是否有旁路电容(The experiment circuit of triode amplification, including fixed bias / partial voltage bias, needs to determine the selected resistance value according to some parameters to make the triode work in the amplification state. In this program, the circuit design is designed into GUI mode. Only the parameters needed for circuit design are needed on the interface. According to the relevant theoretical derivation, the theoretical values of the relevant parameters (magnification, input resistance, output resistance, etc.) are given to guide the construction of experimental circuit. The software is built on Matlab GUI, easy to use)
    2020-04-29 15:11:59下载
    积分:1
  • ANSYS180有限元分析学习宝典命令流
    说明:  ANSYS180有限元分析学习宝典配套的实例命令流(Example command flow of ansys18.0 finite element analysis learning dictionary)
    2020-10-09 09:26:08下载
    积分:1
  • MIMO_detection
    多天线系统的各种信号检测算法包括迫零,最小均方误差,最大似然,改进的最大似然等(A variety of multi-antenna systems signal detection algorithm, including zero-forcing, minimum mean square error, maximum likelihood, the improved maximum likelihood, etc.)
    2021-04-24 20:58:46下载
    积分:1
  • pywofost_4_0_0(1)
    说明:  利用python编程的WOFOST作物模型,进行作物产量等模拟,实现wofost模型。(The WOFOST crop model programmed by Python was used to simulate crop yield and realize WOFOST model.)
    2021-04-12 15:58:57下载
    积分:1
  • 计算文档
    根据W-M的分形函数,生成W-M函数的曲线,请批评指教。(Programme of W-M function)
    2021-03-23 16:29:15下载
    积分:1
  • 使FFT分析信号幅度谱和相位谱
    利用LABview软件的频谱分析功能实现使用FFT分析信号幅度谱和相位谱,(Analysis of Signal Amplitude Spectrum and Phase Spectrum by FFT)
    2018-12-09 13:47:20下载
    积分:1
  • a20040623neta
    A star 算法求解最短路径问题(A star algorithm for the shortest path problem)
    2004-12-13 16:20:17下载
    积分:1
  • Encode5b_4b
    PD里面的4B5B编码,欢迎使用~~~~~~~~~~~~~~~~~(4B5B code in PD3.0 or USB3.0, welcome to use~~~~~~~~~~~~~~)
    2020-12-03 09:09:25下载
    积分:1
  • 696524资源总数
  • 103971会员总数
  • 70今日下载