Keil工程建立及设置-Keil establishment and the provision of engineering

基于C51及SL811读写U盘的源程序，开发文档资料,芯片数据手册,测试命令及测试工具,电路原理图,请参C51_SL811_ModeDisk_manual-Based on the C51 and SL811 source disk to read and write U, the development of documentation, the chip data sheet, test orders and test tools, circuit schematic diagram, please refer to C51_SL811_ModeDisk_manual

正转，转四相步进电机，每相间隔70ms。C51程序 51单片机通用。-Is to switch to four-phase stepper motor, each interval of 70ms. 51 Single-chip Universal C51 procedures.

ALTEA EPM7128 CPLD的用于控制三维步进电机的VHDL源代码-ALTEA EPM7128 CPLD is used to control the stepper motor of three-dimensional VHDL source code

Msp430的flash读写文件配置文件，(msp430f427芯片)-MSP430

基于C51的SHTXX温湿度传感器的驱动程序，可移植性好，模拟IIC协议-C51 based on the temperature and humidity sensors SHTXX driver, portability, and simulation IIC agreement

本程序是下个双通道充电器的原程序,充两节NI-MH电池,-This procedure is the next dual-channel charger for the original procedure, two rechargeable NI-MH battery,

使用ADC模块的通道0、1进行电压的测量，然后将转换结果从串口输出。-0,1-channel ADC module used for voltage measurement, and then convert the results from the serial port

用keil c编写的PID算法,不错噢.-with keil c prepared by the PID algorithm, Oh Yes. Ha ha

easyarm 1138 用c语言开发的 2401无线 发送程序-easyarm1138 c 2401 send