登录
首页 » SCM » 是实验操作过程的详细讲解,有源程序即控制:转,停;正,反;快,慢;...

是实验操作过程的详细讲解,有源程序即控制:转,停;正,反;快,慢;...

于 2022-01-24 发布 文件大小:29.79 kB
0 192
下载积分: 2 下载次数: 1

代码说明:

是实验操作过程的详细讲解,有源程序即控制:转,停;正,反;快,慢;-experimental operation is the detailed talks, a source that is control : turn and stop; Now, anti-; Fast, slow;

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 本要求适用于Microcon
    本要求适用于Microcon-T02半导体冰箱控制板(以下简称控制板)。本控制板由电源板、显示控制板两部分组成。-The requirements apply to Microcon-T02 semiconductor refrigerator control panel (hereinafter referred to as the control panel). The control panel from the power supply board, display panel is composed of two parts.
    2022-03-19 18:23:24下载
    积分:1
  • 某公司安装了电子门,要设计门禁系统: 公司的雇员可以凭借密码、胸卡或指纹进入公司 计算机根据雇员的验证方式对其身份进行验证 管理员在监控室可以通过...
    某公司安装了电子门,要设计门禁系统: 公司的雇员可以凭借密码、胸卡或指纹进入公司 计算机根据雇员的验证方式对其身份进行验证 管理员在监控室可以通过按钮直接开启电子门 访客可以按门铃请求进入,由管理员为其放行 管理员可以为新职员设置密码 -A company to install an electronic gate, to design access control systems: the company" s employees can rely on passwords, badges or finger into the company computer, authentication of the employee to verify their identity can be an administrator in the control room directly through the button to open electronic gates that visitors can rang the doorbell of the request to enter an administrator can be released by the administrator of its staff to set a password for the new
    2022-03-04 22:45:32下载
    积分:1
  • C51 TIMER 0的使用 Timer_0_mode_1_timer_gate_hard
    C51 TIMER 0的使用 Timer_0_mode_1_timer_gate_hard-C51 TIMER 0 use Timer_0_mode_1_timer_gate_hard
    2022-02-05 22:48:39下载
    积分:1
  • AD977acn的应用电路及源码,使用凌阳的IDE编写的源码,提供底层的驱动。...
    AD977acn的应用电路及源码,使用凌阳的IDE编写的源码,提供底层的驱动。-AD977acn circuit and the application source code, the use of Sunplus IDE prepared by the source. for the bottom of the drive.
    2022-07-25 10:18:20下载
    积分:1
  • 8051+ 24c01
    8051+24c01电话
    2022-10-24 12:25:03下载
    积分:1
  • 完整的I2C软件开发包,包括模拟的I2C和硬件I2C,并且每种都有汇编和C语言两种...
    完整的I2C软件开发包,包括模拟的I2C和硬件I2C,并且每种都有汇编和C语言两种-complete software development kits, including simulation and hardware I2C I2C, and the compilation and each have two C language
    2023-06-08 09:35:03下载
    积分:1
  • 应用actel公司的a3p030进行调试通过的LCD1602显示程序 可以应用此程序进行网站显示 等...
    应用actel公司的a3p030进行调试通过的LCD1602显示程序 可以应用此程序进行网站显示 等-Application a3p030 company actel debug LCD1602 display program adopted this procedure can be applied to web display.
    2022-07-25 12:09:06下载
    积分:1
  • PHILIPS非接触射频卡RC500的开发技术资料,
    PHILIPS非接触射频卡RC500的开发技术资料,-PHILIPS non-contact RF Card RC500 development of information technology,
    2023-05-30 21:35:03下载
    积分:1
  • C51 七种实用子程序集 1
    C51 七种实用子程序集 1-C51 seven practical subroutine sets a practical subroutine sets
    2022-01-25 16:40:53下载
    积分:1
  • IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
    IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作: AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位: 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位: 当CLK为低时,在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位,而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
    2022-05-28 08:23:00下载
    积分:1
  • 696518资源总数
  • 106161会员总数
  • 5今日下载