登录
首页 » Matlab » LCMV优化设计阵列处理信号

LCMV优化设计阵列处理信号

于 2022-01-26 发布 文件大小:6.55 kB
0 114
下载积分: 2 下载次数: 1

代码说明:

LCMV优化设计阵列处理信号,相关分析过程的matlab方法,与理论分析结果相比,使用matlab实现智能预测控制算法,使用混沌与分形分析的例程,计算多重分形非趋势波动分析,IMC-PID是利用内模控制原理来对PID参数进行计算。

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Newton-matlab
    Newton牛顿迭代法解非线性方程,这个程序挺不错的,分享给大家(Newton-matlab)
    2010-11-13 15:55:29下载
    积分:1
  • dijkstra Algorithm
    使用Matlab构建函数Dijkstra来实现Dijkstra算法,输入为图点和边长的矩阵,输出为最短路径的矩阵,然后在主程序函数最短路径minRoute中调用该函数来实现某图的寻找最短路径。
    2022-02-07 20:15:47下载
    积分:1
  • ofdm_qpsk_simulation
    说明:  这是matlabR14版本的正交频分复用的仿真程序(This is matlabR14 version of orthogonal frequency division multiplexing of the simulation program)
    2008-10-27 11:27:01下载
    积分:1
  • BezierSurface
    Bezier parametric surface modeling
    2010-04-20 07:09:46下载
    积分:1
  • MOEA
    一篇带约束条件的基于多播QOS多目标算法的论文。(Constraints QoS Multicast Routing Based on MOEA)
    2011-05-14 18:53:41下载
    积分:1
  • CS_beginer_code
    学习压缩感知时自己编写的初步重建程序,有利于加深理解压缩感知的理论(Preliminary reconstruction program, write your own learning compressed sensing, a better understanding of the theory of compressed sensing)
    2012-07-05 21:45:13下载
    积分:1
  • frft_candon
    离散分数阶傅立叶变换,算法参考 C. Candan, M.A. Kutay, and H.M. Ozaktas. The discrete Fractional Fourier Transform. IEEE Trans. Sig. Proc., 48:1329--1337, 2000 (Discrete fractional Fourier transform algorithm reference C. Candan, MA Kutay, and HM Ozaktas. The discrete Fractional Fourier Transform. IEEE Trans. Sig. Proc., 48:1329- 1337, 2000)
    2013-10-23 18:27:29下载
    积分:1
  • pole-placement
    极点配置(Pole Placement)设计是控制系统设计中的一种常用设计方法,它能适应逆不稳系统和开环不稳定系统的情况,并且有设计方法直观、动态性能好、系统稳定的特点。((Pole Placement) pole placement design is a common design approach in the design of the control system can adapt to the inverse unstable system and open-loop unstable system, and intuitive design methods, dynamic performance, system stability characteristics.)
    2012-11-05 17:21:26下载
    积分:1
  • parallel_battery_SC_boost_converter
    这个例子示出了充放电时的超级电容器的模式。该电路示出了与电池超级电容器的一个简单的杂交。超级电容器被连接到降压/升压转换器和电池连接到升压转换器。电池的功率由一个速率限制器块,因此瞬态功率由超级电容器供给到DC总线限制。(This example shows the supercapacitor model during charge and discharge. The circuit illustrates a simple hybridization of a supercapacitor with a battery. The supercapacitor is connected to a Buck/Boost converter and the battery is connected to a Boost converter. Power of the battery is limited by a rate limiter block, therefore the transient power is supplied to the DC bus by the supercapacitor.)
    2021-01-13 11:58:48下载
    积分:1
  • simulation
    时间序列的预测及中间状态,包括误差检测以及其和中间状态的关系(representation of status)
    2010-02-14 06:38:51下载
    积分:1
  • 696516资源总数
  • 106562会员总数
  • 4今日下载