-
wewq
无功补偿仪是用于补充电网无功功率#提高功
率因数!保证供电系统安全运行#减少电能损耗#节
约电能的设备$ 在以单片机 "#$ &’($ 为 $)* 的
无功补偿仪系统中# 我们选用了 +,- ."’/-. 液晶
显示器来显示各相电压 电流 无功功率 有功功率
及波形畸变率等参数$ 本文主要讨论 +,- ."’/-.
的电路连接与软件控制方法# 特别对 +,- ."’/-.
应用的独特之处做了详尽的分析并给出了实例-wewq
- 2022-01-26 08:12:43下载
- 积分:1
-
PCB设计经验,实际应用中的经验和技巧,非常难得.
PCB设计经验,实际应用中的经验和技巧,非常难得.-PCB design experience, the practical application of the experience and skill, very rare.
- 2022-03-21 09:11:53下载
- 积分:1
-
CAN总线传输及液晶显示文章,示例代码
CAN总线传输及液晶显示文章,示例代码-CAN transmission and LCD articles, sample code
- 2022-09-23 01:45:04下载
- 积分:1
-
MSP430的开发实例,有详细的代码和说明,举例说明MSP430单片机的开发和应用...
MSP430的开发实例,有详细的代码和说明,举例说明MSP430单片机的开发和应用-MSP430 development of examples of code and a detailed description illustrate the development and application MSP430 microcontroller
- 2022-01-26 02:40:47下载
- 积分:1
-
MCS
MCS-51单片机有5个中断源,其中两个是由-INT0、-INT1引脚输入的外部中断源;另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式,即下降沿引起中断或低电平引起中断。当编程TCON中的ITi(i=0、1)为1时,则引起触发的方式为边沿触发方式,反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制,即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to
- 2023-07-06 00:00:03下载
- 积分:1
-
PIC microcontroller with the I2C interface writable EEPROM chip (AT24C08. can be...
用PIC单片机的I2C接口读写片外EEPROM(AT24C08,也可以直接用到AT24C01/02/04/16)-PIC microcontroller with the I2C interface writable EEPROM chip (AT24C08. can be used directly AT24C01/02/04/16)
- 2022-01-26 01:17:59下载
- 积分:1
-
介绍了一种利用定时中断为单片机编写高音准的音乐程序的方法,并给出实例程序清单。...
介绍了一种利用定时中断为单片机编写高音准的音乐程序的方法,并给出实例程序清单。-introduces a timer interrupt to the microcontroller prepared Treble-music approach procedures, and gives a list of examples.
- 2023-02-17 01:30:04下载
- 积分:1
-
基于1602LCD的秒表,MCU STC89C51RC。
基于1602LCD的秒表,MCU STC89C51RC。-The stopwatch-based 1602LCD
- 2022-03-24 17:19:59下载
- 积分:1
-
电脑音源切换控制器(带红外功能)
用AT89C251+CD4016切换控制,可控制四路以上的立体音源输入切换,一路立体声输出,有红外遥控PC功能。
电脑音源切换控制器(带红外功能)
用AT89C251+CD4016切换控制,可控制四路以上的立体音源输入切换,一路立体声输出,有红外遥控PC功能。-Computer audio switch controller (with infrared function) with AT89C251+ CD4016 switch control, can control more than four stereo audio input switch, stereo output along the way, has infrared remote control PC functions.
- 2022-01-25 19:21:48下载
- 积分:1
-
ucos
uCOS-II 2.52在51上的移植程序(大模式).rar-uCOS-II 2.52 of the 51 on the transplantation procedure (large model). rar
- 2022-08-03 17:23:22下载
- 积分:1