登录
首页 » SCM » [原创]PIC单片机完成格雷(Golay)编码的源码.

[原创]PIC单片机完成格雷(Golay)编码的源码.

于 2022-01-29 发布 文件大小:1.21 kB
0 120
下载积分: 2 下载次数: 1

代码说明:

[原创]PIC单片机完成格雷(Golay)编码的源码.-[original] PIC completed Gray (Golay) encoding the source.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 单片机控制1420语音芯片发声程序。同时通过485通信方式与外界进行数据通信。...
    单片机控制1420语音芯片发声程序。同时通过485通信方式与外界进行数据通信。-1420 single-chip control procedures audible voice chip. At the same time through the 485 means of communication with the outside world for data communications.
    2022-05-23 00:47:51下载
    积分:1
  • 51在多机通讯时可采用此方式,3线式,忙时可无限等待,闲时传输速率高...
    51在多机通讯时可采用此方式,3线式,忙时可无限等待,闲时传输速率高-51 in the multi-machine communication use this form, a three-line, busy waiting for an unlimited time, in his spare time high speeds
    2023-05-13 10:30:03下载
    积分:1
  • keil C51 Hello事例
    keil C51 Hello事例-Hello stories
    2022-04-19 14:02:18下载
    积分:1
  • LT-1B msp430开发板例子程序-ADC12_09
    2022-01-28 01:22:08下载
    积分:1
  • MSC
    MSC-51 3字节和4字节浮点数计算程序,主要用于数据采集及上传,经过IEEE转换,在上位机直接显示-MSC-51 3-byte and four-byte floating point calculation procedure used mainly for data acquisition and uploads After IEEE conversion, the PC directly show
    2023-01-17 23:05:03下载
    积分:1
  • 三相步进电机的三相六拍工作方式,正转的绕组通电顺序:A、AB、B、BC、C、CA、A,反转的通电顺序:A、AC、C、CB、B、BA、B、A。 由于步进电机转子有一定的惯性以及所带负载的惯性,故步进电机的工作过程中不能及时的启动和停止,在启动时应慢慢的加速到预定速度,在停止前应逐渐减速到停止,否则,将产生失步现象。 步进电机的控制问题可总结为两点: 1、产生工作方式需要的时序脉冲; 2、控制步进电机的速度,使它始终遵循加速、匀速、减速的规律工作。 -Three-phase three-phase stepper motor six shot work, is to order the winding power: A, AB, B, BC, C, CA, A, reverse the order of power: A, AC, C, CB, B, BA, B, A. As the stepper motor rotor has a certain degree of inertia, as well as brought about by the inertia load, the stepper motor during the course of work should not start and stop time, start to be slowly accelerated to a predetermined speed, the stop should be to slow down gradually to the stop, otherwise, will result in out-of-step phenomenon. Stepper motor control problems can be summarized in two points: one, resulting in the need to work the timing pulse 2, control the speed of stepper motor, so that it always followed acceleration, velocity, deceleration of the law of the work.
    2022-07-20 15:21:46下载
    积分:1
  • GPL162001 voice recording and playback of the demo program
    GPL162001语音录制和播放的演示程序
    2022-02-15 16:21:02下载
    积分:1
  • 关于HZ128
    关于HZ128-64D20汉显模块的使用说明-on HZ128- 64D20-significant modules for use
    2022-09-10 05:30:04下载
    积分:1
  • 单片机拼音输入.rar
    单片机拼音输入.rar-SCM phonetic input. Rar
    2022-01-21 21:20:44下载
    积分:1
  • 8X8的点阵图
    schematic diagram of dot matrix 8x8
    2022-03-17 04:35:41下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载