-
摩托罗拉单片机的串行通信中断方式的原代码
摩托罗拉单片机的串行通信中断方式的原代码-Motorola MCU serial communication interrupt the original code
- 2022-06-26 05:41:39下载
- 积分：1
-
done in ICD LCD display clock demonstration program, the compilation of source c...
在ICD做lcd显示时钟演示程序，汇编源代码， 学用液晶的可以参考参考。-done in ICD LCD display clock demonstration program, the compilation of source code, study LCD can refer to the reference.
- 2022-06-19 07:38:52下载
- 积分：1
-
atmega8的关于LED的代码，我自己写的，晶振是11.0592M的。
atmega8的关于LED的代码，我自己写的，晶振是11.0592M的。-atmega8 on the LED code, I wrote it myself, crystal is the 11.0592M.
- 2023-08-16 19:15:03下载
- 积分：1
-
这是一个使用NOKIA 3510I的液晶屏+AVR单片机来制作的电压表，使用AVR单片机内部自带的ADC做电压采样。...
这是一个使用NOKIA 3510I的液晶屏+AVR单片机来制作的电压表，使用AVR单片机内部自带的ADC做电压采样。-This is a use of the NOKIA 3510I LCD+ AVR to produce single-chip voltage table, use the AVR s own single-chip internal voltage ADC sampling done.
- 2022-03-15 17:24:58下载
- 积分：1
-
用单片机蜂鸣器实现911报警声音，采用中断延迟实现输出频率的变换。...
用单片机蜂鸣器实现911报警声音，采用中断延迟实现输出频率的变换。-Used to achieve single-chip buzzer 911 sounds, using interrupt latency to achieve an output frequency of transformation.
- 2022-01-29 00:50:44下载
- 积分：1
-
H4100 RF card driver, the application of tried and tested procedures
H4100射频卡驱动程序，该程序应用久经考验-H4100 RF card driver, the application of tried and tested procedures
- 2022-03-03 03:47:10下载
- 积分：1
-
采用IAR在线调试ADI公司基于ARM7内核的AUUC7026的ADC程序
采用IAR在线调试ADI公司基于ARM7内核的AUUC7026的ADC程序-IAR debug using online ADI Corporation AUUC7026 based on ARM7 core of the ADC program
- 2022-06-14 20:17:09下载
- 积分：1
-
一款采用DS18B20的温度采集汇编程序，本程序为完整的操作实例，方便大家参考...
一款采用DS18B20的温度采集汇编程序，本程序为完整的操作实例，方便大家参考-A temperature acquisition using DS18B20 compilation process, the procedures for the complete operation of examples to facilitate reference to U.S.
- 2022-02-22 12:48:27下载
- 积分：1
-
IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
- 2022-05-28 08:23:00下载
- 积分：1
-
LCD 12864 driver c in both English and Chinese display drivers
液晶12864驱动c 中英文显示驱动程序-LCD 12864 driver c in both English and Chinese display drivers
- 2023-05-31 20:55:03下载
- 积分：1
