-
LPC2103，ADC源码，很好用的，IAR环境下编译
LPC2103，ADC源码，很好用的，IAR环境下编译-LPC2103, ADC source, well used, IAR compiler environment
- 2022-03-02 01:11:20下载
- 积分：1
-
240*160液晶驱动程序，厂家提供的源代码
240*160液晶驱动程序，厂家提供的源代码-240* 160 LCD driver, manufacturers provide source code
- 2022-02-24 21:38:12下载
- 积分：1
-
The use of MCU timer timing, so that the crossroads at the traffic lights turn o...
利用单片机的定时器定时，令十字路口的红绿灯交替点亮和熄灭，实现主支路路口的交通信号灯控制（尽可能保持主线的畅通，即在通常情况下，保持主线的放行，只有在支线到达时，才放行支线），同时采用LCD显示倒计时时间及当前灯的状态-The use of MCU timer timing, so that the crossroads at the traffic lights turn out light and to achieve the main slip road junction traffic lights control (as far as possible the smooth flow of the main line, that is, under normal circumstances, to maintain the release of the main line, and only arrived at the branch only when the release branch), while using LCD display countdown time and the current state of light
- 2022-04-21 01:59:35下载
- 积分：1
-
凌阳61板单片机应用，用到两块61板和一块以太网模组，模组和一块61板实现以太网驱动，另一块61板实现音频播放及辨识...
凌阳61板单片机应用，用到两块61板和一块以太网模组，模组和一块61板实现以太网驱动，另一块61板实现音频播放及辨识-Sunplus 61 plate SCM application, used two plates and a 61 Ethernet module 61 modules and a plate Ethernet driver and the other a 61 plate achieve literacy and Audio Player
- 2023-06-27 06:55:03下载
- 积分：1
-
1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序,...
1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.
- 2023-08-01 05:40:03下载
- 积分：1
-
读取mifareOne卡的数据，并显示在LCD模块上，采用C语言开发，开发编译调试环境KeilC。基于RC522模块。...
读取mifareOne卡的数据，并显示在LCD模块上，采用C语言开发，开发编译调试环境KeilC。基于RC522模块。-Read data from mifare one card and display it in LCD module.
- 2022-03-04 08:46:44下载
- 积分：1
-
TI的CAN接口芯片sn65hvd251的说明。
TI的CAN接口芯片sn65hvd251的说明。-TI s CAN interface chip sn65hvd251 instructions.
- 2022-04-02 08:25:15下载
- 积分：1
-
24c02
24c02-24c512 c51驱动-24c02-driven 24c512 decoder
- 2023-07-17 22:25:03下载
- 积分：1
-
Telephone network
基于电话网络的远程监测系统 附原理图及PCB图-Telephone network-based remote monitoring system attached schematic diagram and PCB
- 2023-03-29 03:15:03下载
- 积分：1
-
单片机控制ic卡的源程序，给需要者，已经通过测试
单片机控制ic卡的源程序，给需要者，已经通过测试
- 2023-03-13 01:10:03下载
- 积分：1
