登录
首页 » 嵌入式系统 » 高速同步串口芯片PEB20534的驱动程序

高速同步串口芯片PEB20534的驱动程序

于 2022-02-15 发布 文件大小:93.52 kB
0 144
下载积分: 2 下载次数: 1

代码说明:

高速同步串口芯片PEB20534的驱动程序-high-speed synchronous serial port chip PEB20534 driver

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 这是一个用于视频切换的控制程序,采用AT89C51芯片,KEIL 51开发
    这是一个用于视频切换的控制程序,采用AT89C51芯片,KEIL 51开发-This is a video switching for the control procedures used AT89C51 chip development KEIL 51
    2022-12-17 20:35:03下载
    积分:1
  • 本程序功能是在FPGA上nios处理器的lcd接口程序。
    本程序功能是在FPGA上nios处理器的lcd接口程序。-The program features in the FPGA on the Nios processor lcd interface program.
    2022-03-11 06:17:20下载
    积分:1
  • I2C总线驱动。与成功测试。实现多字节存储
    I2C总线驱动。与成功测试。实现多字节存储-I2C bus driver. And successfully tested. Multi-byte storage
    2022-10-12 05:40:03下载
    积分:1
  • 从PCI一直讲到PCI EXPRESS的文章,对于理解PCI
    从PCI一直讲到PCI EXPRESS的文章,对于理解PCI-E的发展历程很有帮助-PCI has been mentioned from the article, PCI EXPRESS, PCI-E for understanding the development process very helpful
    2023-01-22 14:35:04下载
    积分:1
  • EB55评价程序的广告
    eb55评估板例程for ads-eb55 Evaluation routines for ads
    2023-05-01 15:50:04下载
    积分:1
  • wps procedures. Wps provided speaks frequently used methods and source code
    wps 操作程序。提供了wps常用的操用方法和源代码-wps procedures. Wps provided speaks frequently used methods and source code
    2022-03-23 08:44:33下载
    积分:1
  • 基于89S51的IO口模拟串口通信,调试通过。
    基于89S51的IO口模拟串口通信,调试通过。-89S51-based simulation of the IO port serial communication, debugging through.
    2023-04-24 12:30:03下载
    积分:1
  • good linux embedded development arm of the Instruction Set
    很好的linux嵌入式开发arm的指令集-good linux embedded development arm of the Instruction Set
    2022-03-12 04:42:21下载
    积分:1
  • STM32一个定时器输出4路频率脉宽任意可调
    利用STM32的一个定时器可以输出4路频率和脉宽任意可调的PWM,C语言,编译环境:Keil MDK V3.5 在stm32103c8rt通过。
    2022-02-07 10:27:21下载
    积分:1
  • Xilinx IIC IP
    由 Xilinx 提供的 IIC 接口,使用 AXI interface。 Features ‧ AXI interface is based on the AXI4-Lite interface ‧ Master or slave operation ‧ Multi-master operation ‧ Software selectable acknowledge bit ‧ Arbitration lost interrupt with automatic mode switching from master to slave ‧ Calling address identification interrupt with automatic mode switching from master to slave ‧ START and STOP signal generation and detection ‧ Repeated START signal generation ‧ Acknowledge bit generation and detection ‧ Bus busy detec ‧ Fast mode 400 KHz operation or standard mode 100 KHz ‧ 7-bit or 10-bit addressing ‧ General call enable or disable ‧ Transmit and receive FIFOs - 16 bytes deep ‧ Throttling ‧ General purpose output, 1 bit to 8 bits wide ‧ Dynamic Start and Stop generation ‧ Filtering on the SCL and SDA signals to eliminate spurious pulses
    2023-09-07 01:15:03下载
    积分:1
  • 696518资源总数
  • 106161会员总数
  • 5今日下载