-
S3c2410 used sangsung chip companies, through the GPRS module call
采用sangsung公司的s3c2410芯片，通过GPRS模块实现拨打电话-S3c2410 used sangsung chip companies, through the GPRS module call
- 2022-02-03 10:11:25下载
- 积分：1
-
该程序控制的旋转和速度的3个阶段的电机。
This program controls the spin and speed of a 3 phases motor.
- 2022-10-03 18:45:03下载
- 积分：1
-
51单片机+protues仿真交通灯
51单片机+protues仿真交通灯，课程小作业与大家分享，可以实现正常的交通灯运行，紧急情况按键运行
- 2022-01-20 23:49:42下载
- 积分：1
-
MP3系统中USB接口设计，自己去看吧，我就不多介绍了，反正有用...
MP3系统中USB接口设计，自己去看吧，我就不多介绍了，反正有用--USB port design in MP3 system.
- 2022-04-09 12:08:41下载
- 积分：1
-
将CAN现场总线移植到UCOS2中的驱动程序，在BC中调试运行成功
将CAN现场总线移植到UCOS2中的驱动程序，在BC中调试运行成功-CAN fieldbus will be transplanted to UCOS2 the driver, were in BC successful operation Debugging
- 2022-06-02 22:21:22下载
- 积分：1
-
8051 Core FPGA verilog 完整
应用背景Logical separation of program and data memory
All 8051 devices have specific memory organization, they have separate address spaces
for Program (ROM) and Data (RAM) Memory. This logical separation of Memory is
useful because it allows the Data Memory to be accessed by 8-bit addresses, which can
obviously be more quickly stored and manipulated by an 8-bit CPU. Of course, the l6-bit
Data Memory addresses can still be generated with the DPTR register.
Program Memory
Program Memory can only be read, not written to. The address space for 8051 core is 16-
bit, so there is maximum of 64K bytes of Program Memory. Up to 4 Kbytes of Program
Memory can be on chip, internal Program Memory of the 8051 core. For access to
external Program Memory is used signal PSEN (Program Store Enable).
Data Memory
Data Memory is on a separate address space than Program Memory. For external Data
Memo
- 2022-01-26 05:24:27下载
- 积分：1
-
数字化语音编码回放系统的原理图，使用AT89C52
数字化语音编码回放系统的原理图，使用AT89C52-Playback of digital speech coding system schematic, using AT89C52
- 2023-08-08 10:35:07下载
- 积分：1
-
ZigBee基础实验——GPIO输出控制实验-控制Led亮灭
通过实验掌握CC2530芯片GPIO的配置方法，带你一步步走进嵌入式大门， 掌握Led驱动电路及开关Led的原理。试着看数据手册cc2530-datasheet.pdf由于发光二级管单向导电特性，即只有在正向电压（二极管的正极接正，负极接负）下才能导通发光。P1.0引脚接发光二极管(D1)的负极,所以P1.0引脚输出低电平D1亮，P1.0引脚输出亮电平D1熄灭。
- 2022-01-26 01:21:34下载
- 积分：1
-
CC2540 与 ADXL 346
这是 CC2540 BLE 与 ADXl 346 加速度传感器的接口代码。接口是通过 SPI。C.在完成初始化和阅读它读取设备 ID/寄存器/XYZ 值。
- 2022-07-25 19:27:37下载
- 积分：1
-
LM24064 application. It only shows 1 picture.
LM24064的开发程序,只显示一张图片--LM24064 application. It only shows 1 picture.
- 2022-04-09 08:37:58下载
- 积分：1
