登录
首页 » SCM » IDE

IDE

于 2022-02-27 发布 文件大小:7.17 kB
0 180
下载积分: 2 下载次数: 1

代码说明:

IDE-ATA硬盘驱动器的ARM控制源代码-IDE-ATA hard disk drives to control the source code of the ARM

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • DAC1230 is a 12
    DAC1230是一个12位的模数转换的芯片!而使用时候是在8位的单片机上运行,所以需要注意高四位和低八位的写入时序-DAC1230 is a 12-bit analog-digital conversion chips! Use of time in the 8-bit single-chip run, so it is necessary to pay attention to the high four and low eight write timing
    2022-10-13 04:50:03下载
    积分:1
  • 让数码管的亮度一致,原代码是运行在AT89S52上,12MHz
    让数码管的亮度一致,原代码是运行在AT89S52上,12MHz-The brightness of the digital control line, the original code is run on AT89S52 on, 12MHz
    2022-02-09 21:35:35下载
    积分:1
  • 汽车领can总线通讯程序,属于一个demo的程序,非常有参考价值,请大家用的时候最好有can总线的知识...
    汽车领can总线通讯程序,属于一个demo的程序,非常有参考价值,请大家用的时候最好有can总线的知识-Automotive collar can bus communication procedures, the procedure is a demo, very useful, please use the time everyone can have the best knowledge of bus
    2022-01-27 10:39:12下载
    积分:1
  • 小灯控制程序用51系列
    小灯控制程序用51系列-small lights control procedures used 51 Series
    2022-02-06 11:56:51下载
    积分:1
  • err
    通讯规则: 1:时钟7.3728 MHz/波特率9600/9个数据位/奇校验/1个停止位/硬件多机通讯功能/ 2:通讯连接采用硬件MAX485,双向单工 3:每个上行/下行的数据包的字节个数都是一样的(通讯数据量) 4:每个上行/下行的数据包都采用CRC8校验 5:数据接收采用中断+查询的方式 6:总是由主机向从机发送一个数据包,从机收到数据包后向主机回复一个数据包 7:不管是主机还是从机,如果收到的数据包有任何错误,都将丢弃该数据包,等效于没有接收 8:从机之间不能相互通讯,必须通过主机才能交换数据 9:无效地址是0,主机地址是1,从机地址是2.3.4......广播地址是255 -err
    2023-04-26 20:15:03下载
    积分:1
  • source code for avr
    source code for avr
    2023-05-22 20:15:03下载
    积分:1
  • 字模的提取程序,应用于单片机的小应用程序
    字模的提取程序,应用于单片机的小应用程序-Matrix extraction procedure, applied to small single-chip applications
    2023-03-22 15:40:04下载
    积分:1
  • Developed under VC serial debugging tools, the interface simple, convenient oper...
    VC下开发的串口调试工具,界面简单,方便操作,适用于PC机下与单片机通过串口通信-Developed under VC serial debugging tools, the interface simple, convenient operation, applicable to PC machines with single-chip through the serial communication
    2022-02-26 17:58:31下载
    积分:1
  • 对16*2字符型点阵驱动的C51代码,已经在拓普微上测试通过。
    对16*2字符型点阵驱动的C51代码,已经在拓普微上测试通过。
    2023-02-17 09:05:04下载
    积分:1
  • 利用无线模块开发的报警器源程序,此程序已在产品中使用
    利用无线模块开发的报警器源程序,此程序已在产品中使用-The use of wireless module developed by alarm source, this procedure has been used in the product
    2022-07-11 08:09:56下载
    积分:1
  • 696516资源总数
  • 106913会员总数
  • 8今日下载