登录
首页 » DSP设计 » Single

Single

于 2022-03-01 发布 文件大小:4.87 kB
0 111
下载积分: 2 下载次数: 2

代码说明:

单片机于DSP通过主机接口(HPI)进行通信-Single-chip in the DSP through the host interface (HPI) to communicate

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 三环伺服控制源码(位置,速度,电流)
    带传感器永磁同步电机伺服控制,芯片为TI TMS320F28035。硬件为TI的开发套件,电路图为1.7版的电路原理图;电机为米格750W 80ST的电机,3000rpm,编码器反馈(2500线),参数整定是根据化工的博士论文及相关书籍。
    2022-04-10 05:43:34下载
    积分:1
  • Definitely a good source, DM642 achieved H264 algorithm, compiled in the CCS, th...
    绝对好的源码,DM642上实现了H264算法,在CCS 上编译通过 NO ERROR-Definitely a good source, DM642 achieved H264 algorithm, compiled in the CCS, through NO ERROR
    2022-08-20 02:08:26下载
    积分:1
  • 源程序是在VisualDSP环境下开发出来的,目标处理器是4片AD公司的TS1O1 DSP。IDE_FAT32用来在硬盘上创建FAT32文件系统;2)i2c_t...
    源程序是在VisualDSP环境下开发出来的,目标处理器是4片AD公司的TS1O1 DSP。IDE_FAT32用来在硬盘上创建FAT32文件系统;2)i2c_test编写IIC总线;3)codec_a_in_pal_cf_frame是加载到FLASH的程序,板子在脱离PC自动上电时会把PAL制的图像直接存到CF卡里,CF卡的文件系统是FAT16;4)codec_a_in_pal_buf_boottest是可加载的DSP图像直通程序;5)ADSP-TS101prog_driver是flash的驱动程序。-source of the VisualDSP environment developed, targeted four processor is the company"s AD TS1O1 DSP. IDE_FAT32 used in the drive to create FAT32 file system; 2) to prepare i2c_test IIC bus; 3) codec_a_in_pal_cf_frame FLASH is loading procedures, the board automatically from the PC on when power will be the PAL system images directly to CF card, the CF card is the FAT16 file system; 4) can be loaded codec_a_in_pal_buf_boottest DSP image through procedures; 5) ADSP-TS101prog_driver flash is the driver.
    2023-04-30 13:30:04下载
    积分:1
  • fft 1024点实现
    用VHDL硬件描述语言编写的fft算法,很是经典,和大家共享,希望能对大家有所帮助。-VHDL hardware description language with the preparation of the fft algorithm, it is a classic, and we share the hope that it can be helpful to everyone.
    2022-10-04 00:40:03下载
    积分:1
  • 数字信号处理器集成开发环境
    dsp集成开发环境―ccs及dspbios的原理与应用(配套源码),希望可以对大家有用-dsp integrated development environment-ccs and dspbios and application of the principle of (matching FOSS), We hope to be useful
    2022-05-14 16:34:14下载
    积分:1
  • 在 Vhdl 中的 ALU
    此代码将生成在 Xilinx 设计套件中使用 IP 核心的铝块。IP 核心是智能财产,我已经使用的 IP 内核在这里都是免费的成本。IP 核心是可靠和测试之前释放。这样的代码覆盖率和快速执行。
    2022-10-10 19:00:03下载
    积分:1
  • ADSP
    针对ADSP-BF533的例程,代码可以直接引用,测试IDE的,软件开发环境为VisualDSP-ADSP-BF533 for the routines, the code can be directly quoted, test IDE, and software development environment for VisualDSP
    2022-11-01 19:10:03下载
    积分:1
  • 录DEC6713的UART串口的测试程序。需要将板上的跳针JP3、JP5各自短接,将UART通道A 和通道B均配置为RS232方式。...
    录DEC6713的UART串口的测试程序。需要将板上的跳针JP3、JP5各自短接,将UART通道A 和通道B均配置为RS232方式。-Recorded in the UART serial DEC6713 test procedures. Need to jump on-board pin of JP3, JP5 their shorted to UART channel A and channel B are configured for RS232 mode.
    2022-02-11 21:09:41下载
    积分:1
  • tms320lf2407 25AA320 module (EEPROM) to read and write procedures, unpacked, a d...
    tms320lf2407中SPI模块与25AA320(EEPROM)读写程序,解压后,目录有CCS2.2环境下的所有程序,可以直接运行-tms320lf2407 25AA320 module (EEPROM) to read and write procedures, unpacked, a directory CCS2.2 environment all the procedures can be run directly
    2023-04-19 23:45:03下载
    积分:1
  • dsp I2C 通信例程,本例介绍了DSP的I2C模块和EEPROM间通信
    dsp I2C 通信例程,本例介绍了DSP的I2C模块和EEPROM间通信-dsp I2C communication routines, in this case describes the DSP-I2C communication between modules and EEPROM
    2022-03-05 06:14:17下载
    积分:1
  • 696518资源总数
  • 105873会员总数
  • 12今日下载